Re: Computer will not go past boot from cd page

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance



"momandwife" <momandwife@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:7FE4D75F-8B59-486C-9733-B307A5F7097F@xxxxxxxxxxxxxxxx
My computer will not go past the boot from cd page. It freezes there. Is
there anything I can do or do I have to run the recovery cd. If that is
the
case, could you direct me to where I can get the instructions for that. I
misplaced the ones that I had. Thanks for any help.

The last thing you see is the "press any key to boot from CD" line?

If that's the case, the recovery CD may not help at all. If it's hanging
at this point, the system may not be aware that the hard disk has any
contents at all.

This could be due to a number of things, from drive controller failure to
drive failure to loose cable.

If you wait long enough, up to five minutes or more (15 would be too long)
you may see some sort of error message.

If the system has a floppy drive, get a boot floppy from anywhere. Set the
BIOS boot sequence to ignore the hard disk (temporarily), and set it to boot
from CD then floppy. After seeing if the results are different, switch
the sequence to boot from floppy first.

If you can, physically disconnect the hard disk. If the problem
persists, it may have nothing to do with the hard disk itself (though the
hard disk contents may - or may not - be damaged now). While you have the
drive out, back up any valued data to another system.

-pk


.



Relevant Pages

  • Mystery Solved - Boot CEPC from Hard Disk
    ... The reason for this is that as you increase the size of your partition (why ... Download and install the IDE and floppy drivers from the same site. ... Boot the device (BTW, the "Del" key is the key that gets you to the ... and the NK.bin file will get copied over to your hard disk. ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Transfer Of Floppy Boot Sector To Hard Disk
    ... I have a 486 machine which boots from a floppy. ... I want to make the machine boot from a hard disk, ... I installed ms-dos on a hard disk and made sure that the machine can ... but if you're seeing named files - more than one - then whatever runs after boot must have support for a FAT12 file system. ...
    (alt.lang.asm)
  • Re: Rebuilt Mirror Wont Boot
    ... I would not be able to boot from the floppy since it is not on ... I am still at square one with a server that I can boot off a floppy ... I cannot boot the server using the same boot.ini file on the C drive. ... Boot.ini should be the same on the floppy and on the hard disk. ...
    (microsoft.public.windows.server.general)
  • Re: Hmm.....ho hum......
    ... Continuously, in some cases, if the BSoD happens during the Boot ... out probs like that using the "Recovery Console" Command Line thingy ... you to Format the Hard Disk yourself & then do an ordinary Install, ...
    (uk.people.silversurfers)
  • Re: Cannot use recovery disc.
    ... You probably need to set the system to boot to the CD. ... in the floppy drive. ... > recovery and pressed r for recovery. ... > non-system disc or disc error. ...
    (microsoft.public.windowsxp.help_and_support)