RE: USB Connection
REDWAGON wrote:
> Not sure what you mean by "I connected the wire to the internal USB
> header...." but on all of my CPU cases that have external USB, IEEE1393,
> Audio, or Mike ports, there was always connectors that had to be connected
> to particular pins on the mother board (assuming your mother board has
> such optional pins for this purpose.
>
Then learn what a "USB header" is and you won't make such a silly reply in
the future.
> Frank....
>
> "Daniel" wrote:
>
>>
>> Hey All
>>
>> I just purchased an ANTEC enclosure for my PC. I was able to switch
>> everything over without any major problems. The one problem I am having
>> is getting the front panel USB ports to work. I connected the wire to the
>> internal USB header but when I plug a USB device a message saying "
>> UNKOWN USB DEVICE". I'm not sure if this is an issue with the new
>> tower,my Motherboard or with WIN XP. Does anyone have any ideas on what I
>> can do to get it working?
>>
>> Dan
.
Relevant Pages
- Re: a USB for the Apple II smoke test
... > merely a rewiring of the connectors. ... > A quick search doesn't turn up the voltage levels for USB, ... One level of incompatibility. ... > USB is a serial interface, but is it the same protocol as used ...
(comp.sys.apple2) - Re: A7N8X V2 Deluxe MB and Atec P160 Case Front Panel Connection
... Thanks Paul I will have a look at the card you mentioned. ... >> The Antec case comes with one connector for each USB ... >> to the two USB 2 connectors but nothing for the firewire. ...
(alt.comp.periphs.mainboard.asus) - Re: VIA KT400 + Kernel 2.6.12 + IO-APIC + uhci_hcd = IRQ trouble
... My Gigabyte GA7-VAXP motherboard has 6 USB connectors. ... 00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 ...
(Linux-Kernel) - Problems With All USB Devices Connected to Dimension 8300
... Am not using a USB hub, and all devices are connected directly to the available USB ports on the back of the PC. ... I also have three PNY Attaché flash drives, all USB-2, which ... The only way to fix the problem is to disconnect the power and USB connectors from the back of the printer, ... I use this for backing up my hard drive, and it probably the most important USB device I have. ...
(alt.sys.pc-clone.dell) - Re: Problems With All USB Devices Connected to Dimension 8300
... Am not using a USB hub, and all devices are connected directly to the available USB ports on the back of the PC. ... I also have three PNY Attaché flash drives, all USB-2, which I use the front-two USB ports to connect to. ... The only way to fix the problem is to disconnect the power and USB connectors from the back of the printer, ... So, I plugged the flash drive into the 2nd connector on the front of the Dell, and it was detected without problem. ...
(alt.sys.pc-clone.dell) |
|
