Re: Front USB port problems
- From: Javier <Javier@xxxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Tue, 19 Apr 2005 13:21:06 -0700
Well the conectors are square and separated, not 1 whole connector for all
but 1 little connector for each cable, they are clearly marked, and I have
them connected as it says in the instructions. I don't know what to do... is
there a way to test them to know if the ports are ok? the ports came
separately from my case.. I bought them later....
"Jim Macklin" wrote:
> Most likely you have the + and - data wires switched.
>
> The D865GBF uses the Intel standard layout, but what case do
> you have and as another asked, what cable are you using?
>
>
> --
> The people think the Constitution protects their rights;
> But government sees it as an obstacle to be overcome.
>
>
> "Javier" <Javier@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
> news:BD235A7A-1D9E-4670-8161-F27B59B81709@xxxxxxxxxxxxxxxx
> | My mother board is an Intel D865GBF I have read over and
> over the USB header
> | Pin out and I connected it correctly, I downloaded the USB
> 2.0 drivers and
> | installed them, windows recognizes the ports, now instead
> of having 4 now I
> | have 8, the problem is when I connect something to the
> front usb ports,
> | windows does not recognize the device, for example my usb
> memory, it is fine
> | if I connect it to the back but not in the front.
> |
> | As I said is there a way to test the ports to see if they
> are the ones at
> | fault, or is it a configuration problem???
> |
> | "Lil' Dave" wrote:
> |
> | > I had a motherboard that required a jumper to be set to
> enable the mobo
> | > ports. I'm not speaking of the USB ports on the back of
> the PC. If it is
> | > correct, possbly, the port may be 1.1 only vice 2.0, and
> you're attempting
> | > to use a 2.0 device.
> | > "Javier" <Javier@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in
> message
> | >
> news:E9AD77FC-62F1-46D7-8118-9CC7DD0B357F@xxxxxxxxxxxxxxxx
> | > > Hi, I am trying to install the front USB ports for my
> mother board, I have
> | > > checked and rechecked the order of the connectors and
> they are correct,
> | > > windows recognizes them but when I connect anything to
> the ports, windows
> | > > says that it does not recognize the device, even
> though when I connect
> | > them
> | > > to the ports in the back there are no problems, is
> there a way to test the
> | > > ports so I can know were the problem is laying?
> | > > My motherboard does accept front USB ports 4 in total
> | > > I have sp 1 installed
> | > > and have XP pro
> | >
> | >
> | >
>
>
>
.
- References:
- Front USB port problems
- From: Javier
- Re: Front USB port problems
- From: Lil' Dave
- Re: Front USB port problems
- From: Javier
- Re: Front USB port problems
- From: Jim Macklin
- Front USB port problems
- Prev by Date: Re: problem persists
- Next by Date: Re: User Account problem
- Previous by thread: Re: Front USB port problems
- Next by thread: removing ghost 9.0 tray icon by 'msconfig' is dangerous for incremental backups
- Index(es):
Relevant Pages
|
