Re: Master Boot Record
- From: Howard <Howard@xxxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Sat, 16 Apr 2005 22:58:02 -0700
Hi David
> You'll need Dos to do this. To repair one in XP type FixMBR in Help.
Is the DOS program relating to the commands which you mentioned in your
response found in windows or is this some third party DOS program??
What "Help" source are you referring to: Start menu/Help and Support ???
> Warning - Read This - Warning
> If you don't know why you'd want to restore or backup a boot sector then don't do it. If you get it wrong you may render all your drives on this disk unusable.
>
> This is used by people who have multiple operating systems or wierd requirements. It's not useful for 99.9999% of computers.
>
> To repair a boot sector use Scandisk, Sys command, or FDisk /mbr. If your partition table (part of the boot record) gets scrambled only scandisk might help. Don't run Sys or FDisk /mbr with a damaged partition table.
>
> Backing up is safe enough (as long as you follow the instructions exactly, then check each line before pressing enter), but restoring is dangerous.
>
> If you are thinking of doing this because you think it's an extra safety step then it's not needed as Fat32 drives back up their own boot sectors.
>
> And again, you may notice the lack of warnings on this site compared to other similar sites, so this warning should be considered important rather than a general disclaimer.
What Site are you talking about ???
>
> Readme Next
> The boot sector contains a computer program that loads Dos or Windows. It also contains the partition table.
>
> Virus checking in the BIOS or by programs must be disabled to write to a boot sector. Windows also prevent programs writing to the boot sector.
>
> To Create a Backup Boot Sector and Partition Table
> To create a backup of your boot sector and partition table type the following lines at in MSDos mode. Bold text shows the prompt and should not be typed but is what you can expect to see. Text in italics also aren't typed but are instructions or explainations to you.
Are you talking about using Windows Command Prompt as a means to type in
these DOS commands. I don't think so - I tried several of these commands -
couldn't get anything to come up !!
>
> C:\WINDOWS>lock c:
>
> WARNING: The LOCK command enables direct disk access by programs
> that can CORRUPT file names and/or DESTROY disk data, resulting in the
> loss of files on your disk.
>
> Are you sure (Y/N)?Y
>
> C:\WINDOWS>debug
> -L 0100 3 0 1 The second parameter is the drive we're backing up, we're doing C here, 3=C 1=A 2=B 4=D ect
> -rcx
> CX 0000
> :200 enter 200 (200 hex = 512 bytes the size of the boot sector, CX control how many bytes we'll write to file)
> -n a:\bootsect.bak the name of the file to backup the boot sector to
> -w write 200h or 512 bytes to a:\bootsect.bak
> -q quit debug
> C:\WINDOWS>unlock c:
> To view your boot sector press D<enter> 4 times after the L 0100 3 0 1 line. All boot sectors end with 55 AA in hex.
>
> To check that the file is probably OK make sure it's size is 512 bytes exactly, then view it in Edit with the following command line;
>
> edit /78 /r a:\bootsect.bakthe last two characters should be U (55) followed by a right angle (AA) with the corner in the upper right.
>
> To Restore a Backedup Boot Sector and Partition Table
> To restore a backup of your boot sector and partition table type the following lines in MSDos mode. Bold text shows the prompt and should not be typed but is what you can expect to see. Text in italics also aren't typed but are instructions or explainations to you.
>
> C:\WINDOWS>lock c:
>
> WARNING: The LOCK command enables direct disk access by programs
> that can CORRUPT file names and/or DESTROY disk data, resulting in the
> loss of files on your disk.
>
> Are you sure (Y/N)?Y
>
> C:\WINDOWS>debug
> -n a:\bootsect.bak the name of the file that contains backedup the boot sector
> -L load the file specified by n
> -rcx
> CX 0200 check that it says 0200, if not quit (press enter, the Q, then enter) - something is wrong with the file or it wasn't loaded (200 hex = 512 bytes the size of the boot sector, CX contains how many bytes we read from the file)
> :Press enter this leaves CX unchanged
> -W 0100 3 0 1 The second parameter is the drive we're restoring to, we're doing C here, 3=C 1=A 2=B 4=D ect
> -q quit debug
> C:\WINDOWS>unlock c:
> To view your boot sector before writing it press D<enter> 4 times after the L line. All boot sectors end with 55 AA in hex.
>
>
> --
> ----------------------------------------------------------
>
> "Howard" <Howard@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message news:AE4555E9-36B4-481A-BAB1-FCC026BEF965@xxxxxxxxxxxxxxxx
> >A few questions about the Master Boot Record (MBR)
> >
> > (1) Is sector One (MBR) considered to be located in unallocated space
> > immediately before the first partition of the hard drive ???
> >
> > (2) Using partion Magic, I notice that my first partition starts at sector
> > 63 - what else is included on these 62 some odd sectors in front of the first
> > partition and is this space also considered unallocated space
> >
> > (3) How can you obtain any info about the MBR (read it, view it, write it,
> > save it, copy it, etc) I am particularly interested in knowing how you can
> > copy or save the MBR and also how you can restore the MBR for cloning or
> > restoration purposes. Does Windows have any utilities for this?? Can anyone
> > recommend any other third party programs/utilities??
> >
> > (4) Is the so called boot program in the MBR a standard type of program or
> > is it a specific program that is unique to your operating system??
> >
> > (5) If you take a hard drive fully erased (the whole drive written to zero's
> > and you
> > partition the drive with partition magic (DOS version) before you do
> > anything else - is a fully functional MBR created at that point or is an MBR
> > only created when an operating system is installed??
> >
> > (6) Although I have read several articles on MBR, some really good
> > references on this topic would be greatly appreciated!!!
> >
> > Thank you for your time
.
- References:
- Master Boot Record
- From: Howard
- Master Boot Record
- Prev by Date: Re: Problem located with msconfig...how to delete?
- Next by Date: Re: System file checker is asking for pro CD when I have home
- Previous by thread: Re: Master Boot Record
- Next by thread: Local mandatory user profiles in Windows XP
- Index(es):
Relevant Pages
|
