Re: Trap exception

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

From: ittech (ittech_gov_ontremove)_at_hotmail.com)
Date: 11/24/04


Date: Wed, 24 Nov 2004 00:55:06 -0800

NIC doesn't help.

If it is a resistor to your MB, the machine is probably Over Clocking and
cannot handle it, to much power to the CPU.

Does the BIOS in you Compter show you voltages and/or temperature scores?

I would get another MB, probably is cheaper than to get someone to repair
it.

But then it might not be MB, do you have another Power Supply you can try,
if that fails I would suggest a new MB.

These are only suggestions.

-- 
ittech
"Christian Borchgrevink-Vigeland" <borchgrevink@yahoo.com> wrote in message 
news:41a4462a$1@news.wineasy.se...
> Thanks
>
> Only diagnostics on the NIC I think. Does that help?
>
> Have tried to remove ALL PCI cards except graphics and my HDs. If it is a 
> resistor, that means my MB is broken?
>
> Thanks again
>
>
> "ittech" <ittech_gov_ont(remove)@hotmail.com> wrote in message 
> news:O80e6pf0EHA.3900@TK2MSFTNGP10.phx.gbl...
>> Do you have Diagnostic lights in the back of your computer. If so check 
>> the diagnostic codes in your manual. They might give you a better 
>> indication of what is happening. If they are all green, usually means 
>> things are OK.
>> Also I was talking to some people about this, they said it could be a 
>> fried resistor that supplies power to your CPU (there is usually 4 or 5 
>> of them) on your motherboard. Also they said could be a hardware item 
>> (like a hard drive or video card) has failed.
>>
>>
>>
>> -- 
>> ittech
>>
>>
>> "Christian Borchgrevink-Vigeland" <borchgrevink@yahoo.com> wrote in 
>> message news:41a4392d$1@news.wineasy.se...
>>> Hmm, I am a bit lost now. Have tried with other RAM, so it is not RAM. 
>>> Have tried to flash BIOS, did not work. One odd thing: My system will 
>>> only boot from floppy whem it has been turend of for some minutes, or 
>>> else I get "Non-system-disk" error.
>>>
>>> This suggests a heat issue to me, but fans are running normally and have 
>>> in addition cleaned CPU fan.
>>>
>>> Any ideas?
>>>
>>>
>>> "Christian Borchgrevink-Vigeland" <borchgrevink@yahoo.com> wrote in 
>>> message news:41a2e871@news.wineasy.se...
>>>> Have SP2. Suddenly it all stopped working. Right after the BIOS post, 
>>>> when XP is about to load, i get a "Trap exception" (more details 
>>>> available if needed), and sometimes a "General protection fault". Have 
>>>> not installed new hardware/software. Most often a "trap exception". 
>>>> Tried to boot from XP CD to get to repair consol, but not possible. Any 
>>>> suggestions? Thank you very much!
>>>>
>>>> Christian
>>>>
>>>
>>>
>>
>>
>
> 


Relevant Pages