Re: Page Fault in NonPaged Area
From: Alex Nichol (alexn.mvpdts_at_ntlworld.delete.com)
Date: 08/25/04
- Next message: Abhi: "LPT1 - Dos Commands not working after installing SP2"
- Previous message: Alex: "updmgr.exe"
- In reply to: John Feagin: "Page Fault in NonPaged Area"
- Messages sorted by: [ date ] [ thread ]
Date: Wed, 25 Aug 2004 16:54:32 +0100
John Feagin wrote:
>I get the Page Fault message when I do a fresh boot-up along with the
>blue screen and the numerals 0X00000050. If I do a "Safe" boot and
>then reboot the error does not appear. I just reinstalled XP and
>updated it to SP2. This is because I had 3 worms and to viruses that
>killed the first setup.
You have something around that loads in normal mode, but not in safe
mode, and which is using this non-paged area - part of memory that
should only be for central critical components. One thing that does
load there is Norton stuff: try removing anything you have of theirs.
Other than that might be a bad driver, for which Video is prime suspect.
At the boot menu instead of Safe mode try Enable VGA - if that boots
then get new video drivers from your video card maker's site
-- Alex Nichol MS MVP (Windows Technologies) Bournemouth, U.K. Alexn@mvps.D8E8L.org (remove the D8 bit)
- Next message: Abhi: "LPT1 - Dos Commands not working after installing SP2"
- Previous message: Alex: "updmgr.exe"
- In reply to: John Feagin: "Page Fault in NonPaged Area"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
