I think i did something bad...

From: jeff (anonymous_at_discussions.microsoft.com)
Date: 08/13/04 

Date: Fri, 13 Aug 2004 07:05:13 -0700

Last night I was installing SP1 for XP and after it had
finished downloading and installing but before I
rebooted, I did a search a on my C: drive for *.tmp and
deleted the results. Then when I went to reboot the
computer will display the windows home edition screen
with the status bar, but then it automatically recycles
the power and starts over. The pc stays in this loop.
If I try safe mode, it runs through some files in the
system32 directory until it gets to mup.sys, then the
same cycle repeats. I have also tried going back to my
last good configuration, but the same thing happens. Is
there anything I can do?

Relevant Pages

  • Re: XP Pro Service Pack 1
    ... Data should be safe. ... SP1 will need to be reloaded after Repair Installation. ... It is best to resolve current issues BEFORE installing SP1. ... After SP1 install is completed, reboot, defrag. ...
    (microsoft.public.windowsxp.security_admin)
  • microsoft.public.windows.server.networking
    ... I seem to have developed a problem after installing SP1. ... I reboot as requested. ... then ping adapter 2 and end up with 25% packet loss. ...
    (microsoft.public.windows.server.networking)
  • Fixed Server 2003 SP1 Problem
    ... After installing SP1 on my Windows 2003 Standard Edition that is doing the ... webserver job something very strange in going on. ... the outside again and ok from the inside; now if I reboot it, ...
    (microsoft.public.windows.server.general)
  • Problem with SHLWAPI
    ... I was installing SP1 on Windows XP Home Edition and lost ... power in the middle of the install. ... When I reboot it will ...
    (microsoft.public.windowsxp.security_admin)
  • RE: I think i did something bad...
    ... "jeff" wrote: ... > finished downloading and installing but before I ... Then when I went to reboot the ...
    (microsoft.public.windowsxp.general)