it speeds up the process when you open a file that you have previously opened.
After you delete the contents it will get rebuild as you use your computer.
peter
"Chuck" <anonymous@discussions.microsoft.com> wrote in message
news:1765d01c44907$749c1000$a401280a@phx.gbl...
> It was suggested that I delete everything in the
> C:\WINDOWS\Prefetch file to correct some possile
> problems. Would that create any additional problems and
> what does this folder do? Thanks, Chuck
No clue why Comcast triple posted... ... up put the chuck on the JET midi lathe and now I'm concerned about my drive head bearings. ... Fortunately the JET variable speed starts at 500 rpms but the slow speed seems to conflict with the general consensus that higher speeds are better than lower speeds. ... Also picked up Raffan's tape - his skew seems an extension of his arms and hands. ... (rec.crafts.woodturning)
Re: Got The Chuck & Fear For My Bearings ... up put the chuck on the JET midi lathe and now I'm concerned about my drive head bearings. ... Fortunately the JET variable speed starts at 500 rpms but the slow speed seems to conflict with the general consensus that higher speeds are better than lower speeds. ... Also picked up Raffan's tape - his skew seems an extension of his arms and hands. ... (rec.crafts.woodturning)
Re: Got The Chuck & Fear For My Bearings ... up put the chuck on the JET midi lathe and now I'm concerned about my drive head bearings. ... Fortunately the JET variable speed starts at 500 rpms but the slow speed seems to conflict with the general consensus that higher speeds are better than lower speeds. ... Also picked up Raffan's tape - his skew seems an extension of his arms and hands. ... (rec.crafts.woodturning)
Re: Simple Strobe Tach ... But, when I was curious about what the actual spindle speeds on my old Stark lathe were after I'd bought it and fitted it up with a step V-belt pully and a Craftsman speed change pully rig made for use with wood lathes, I did this: ... I securely taped a small magnet on the inside of one of the chuck jaws, hooked an old relay coil across the input of my oscilloscope, held the coil near the spinning chuck, measured the pulse spacing with the scope's time base, and did the math. ... (rec.crafts.metalworking)
An Unusual (to me) Chatter Problem ... It happens at all diameters and most ...reasonable speeds.... If I chuck say a 3.5" long piece of 1" diameter ... in the backplate mounted 3 jaw chuck and take a cut ... (uk.rec.models.engineering)
