Re: Can't get USB mouse to connect

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

anonymous_at_discussions.microsoft.com
Date: 05/08/04 

Date: Fri, 7 May 2004 20:01:26 -0700

>-----Original Message-----
>CS wrote:
>> On Fri, 07 May 2004 20:03:17 -0600, Frank
<Frank@regisassign.com>
>> wrote:
>>
>>
>>>Whenever I try to connect a mouse through a USB port,
it doesn't
>>>connect, it used to connect before and it was working
well now, it just
>>>says "USB Device Not Recognized" I am using a Dell
laptop PC and don't
>>>want to use the touchpad.
>>
>>
>> Try another USB mouse. If that fails to be
recognized, try another
>> USB device (not mouse) using the same port. If the
port is dead, no
>> USB devices will be recognized. If it recognizes a
USB device but not
>> a USB mouse, check the CMOS setup menu to make sure
you have that
>> feature turned on.
>
>well, I got it to work for 2 seconds, lol, then it
disconnected so it's
>not the port, I don't have any other USB mouses though...
>.
>
Hello , I had the same problem with my USB labtec mouse ,
It worked since i bought it , Then one day i restarted
windows and it stopped working through the USB PORTS and
i got 4 USB ports , I'm thinking it's a windows problem ,
Because i put in the USB to PS2 Connector and it works
fine now , When it "did" stop working i went into the
properties for mouse and it said there was no mouse on my
system , Tried to figure out what was wrong but
couldn't , So i just tried my USB to PS2 connector and it
works great , If all else fails go out and buy a USB to
PS2 connector , There very cheap , Just a little
connector piece , If you do find out why the usb mice
stop working for no reason e-mail me at
kekelao@hotmail.com . Thank you and hopefully this helps
you out a bit.

Relevant Pages

  • usb_insert_transfer panic with if_zyd
    ... When I use my ZyXEL G-220 Wireless USB Stick with the if_zyd driver, ... <ACPI PCI bus> on pcib0 ... device problem, disabling port 1 ... <Ethernet over FireWire> on firewire0 ...
    (freebsd-current)
  • 2.6.10-rc1 & ahci & IHC6R & 925X & raid1
    ... usb modules for console, usb keyboard, network and starting a shell. ... ACPI: PM-Timer IO Port: 0x808 ... PCI: PCI BIOS revision 2.10 entry at 0xfb768, ... usbcore: registered new driver hub ...
    (Linux-Kernel)
  • usb does not work on vias smp mainboard
    ... I installed kernel 2.4.21 on an via's mainboard, it seems that the usb ... number of MP IRQ sources: ... PCI Interrupt Link ... Port indicators are not supported ...
    (Linux-Kernel)
  • Re: sata_nv times out for BD-ROM iHOS104-08
    ... generic IDE driver loaded? ... ACPI: PM-Timer IO Port: 0x4008 ... CPU: Physical Processor ID: 0 ... USB 2.0 'Enhanced' Host Controller Driver ...
    (Linux-Kernel)
  • Re: wireless network to wireless network??
    ... box or another fails it is no biggie other then rounding up a replacement ... those USB wireless receivers on the end of a usb cable and have it hooked ... They generally use the port for network attached storage. ...
    (alt.internet.wireless)