Conflicts in I/O Ports

Tech-Archive recommends: Fix windows errors by optimizing your registry

anonymous_at_discussions.microsoft.com
Date: 05/27/04 

Date: Thu, 27 May 2004 04:56:49 -0700

Nothing has been added. Only Norton updates.

>-----Original Message-----
>Have you recently installed a new add-on card ? Or
>changed any settings in the BIOS ?
>
>>-----Original Message-----
>>Getting a "Conflict in I/O Ports" after reading HD's
and
>>CD Drives on startup. Running XP Pro. Gives you a
choice
>>of F1 or Del key.
>>.
>>
>.
>

Relevant Pages

  • Re: Server 2003 Cannot shutdown - after Cloning HD
    ... installation after the successful reboots. ... Verify the write methods set for the hard drive in the system bios and back ... sure and did not find any settings of the sort you mentioned. ... check the DMA settings of the drives. ...
    (microsoft.public.windows.server.general)
  • Re: Problem with booting into WinXP
    ... After it first happened, the Boot ... after POST and BIOS check on booting that goes away when Windows ... Sentinal said that all drives were perfect prior to this problem ... Have you checked the BIOS settings? ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: BIOS SETTINGS
    ... > you boot tells you which key to press to enter Setup (BIOS). ... > of your drives, there should be instructions on which keys to press to ... > delineated to Save Settings and Exit. ...
    (microsoft.public.windowsxp.general)
  • Re: SATA Primary Drive 0 not found, primary drive 1 not found, no DVD found Dell Dimension 4700
    ... I don't have the BIOS for this system memorized, ... Configure SATA as standard IDE ... Having these set wrong can make all of the drives disappear. ... "exact same" settings on the new MB, you copied over the same mistake. ...
    (alt.sys.pc-clone.dell)
  • Re: SATA Boot drive NOT!
    ... It will look where you tell it to look by means of the Bios settings.If you ... >>>SATA Boot drive NOT! ... >>>I now have the Drives as primaries, and the DVD,CD as secondary. ... >>>motherboard settings again. ...
    (alt.comp.periphs.mainboard.asus)