Re: USB 2.0 boot problem
- From: Massimiliano Castelletto <massimiliano.castelletto@xxxxxxxxx>
- Date: Tue, 04 Mar 2008 11:10:00 +0100
Sean Liming (MVP) ha scritto:
I thought that the configuration was good: if I run it using an hard disk all the processes end with no errors; the problems arise when I copy the post-fba files on an USB disk or I try to run the pre-fba directly using the USB disk.
Do you have the USB Boot 2.0 component in the image? http://www.seanliming.com/Docs/USB%202%20Flash%20Boot.pdf
Did you run TAP or TA to get the platform components?
You might be missing a driver - http://www.seanliming.com/Docs/XPE%20Stop%200x0000007B%20Error%20V1.3.pdf
I tryed with two different disks, 1GB each, with the same problems.
I would like to build a simple configuration running over more than one specific hardware in order to use it for maintenance pourposes not depending by the pc. At worst I would like to create a configuration "computer dependent" but I it wasn't successfull.
In the first configuration I tryed using the TAP created configuration, in the second one just inserting some components manually; in both cases the configuration functions saving the file on the hard disk, but doesn't function putting them on the USB disk.
Max
.
- References:
- Re: USB 2.0 boot problem
- From: Massimiliano Castelletto
- Re: USB 2.0 boot problem
- From: Sean Liming \(MVP\)
- Re: USB 2.0 boot problem
- Prev by Date: Re: Shared folders
- Next by Date: 3 USB Modem
- Previous by thread: Re: USB 2.0 boot problem
- Next by thread: Re: driver
- Index(es):
Relevant Pages
|
