Re: XPe newbie needs some help


Sounds like a dual boot / ARC path setup issue - you might want to check
this article out:
http://www.seanliming.com/Docs/XPE%20Dual%20Boot%20Tips.pdf

The ARC path should be 0 0 1 1 for the second drive. The drive letter sounds
like the issue.


Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
XP Embedded Book Author - XP Embedded Advanced, XP Embedded Supplemental
Toolkit



"frankk" <frank@xxxxxxxxx> wrote in message
news:eVhvkPxfHHA.4980@xxxxxxxxxxxxxxxxxxxxxxx
To all,

I downloaded the XPe 2007 SP2 and follow the tutorial of "Building and
Deploying a Run-Time Image" very carefully. I have a SATA first drive as
C: D: E: F: and a blank IDE second drive as G: for testing the image. In
step #4, when defining the target Device setting - should I put in C: boot
path 0 0 0 1 (in the Target Designer help) or G: boot path 0 0 1 1(in MSDN
help). Seems like C: is the correct choice as when I use G:, the boot goes
in a loop.

I copied the image to the G: drive and when I boot the second drive in the
multi-boot I encountered the following error message during the component
installing -

fba.exe application error

The instruction at "0x0319e132" referenced memory at "0x0000000c". The
memory could not be "written"...

I cannot pass this point no matter what I try. I have a high res dual
screen DVI graphic card and a few usb drives hooked to the PC.

Can someone shed some light in what I did wrong?

Thanks in advance,

Frank


.

Relevant Pages

  • Re: BootIt NG high level steps - best approach??
    ... backup boot strategy. ... As far as BING, I should tell you I've been using this software ... make managing your bootable options and partition management so much easier. ... drives) and the DATA partition on a mirrored array. ...
    (comp.sys.ibm.pc.hardware.storage)
  • Re: 160 Gb drive in a removable caddy give "disk error press ctrl alt del" on boot
    ... But the 120Gb does boot. ... so, you're working with only a single mobile rack, right? ... GB HDD it boots & functions just fine, ... The full capacity has always been seen of all drives it is just a boot ...
    (microsoft.public.windowsxp.hardware)
  • Re: how to change out system disk?
    ... Inaccessible_Boot_Device, when trying to boot from the new HD, but sometimes ... WinXP booted, you can still run Word, Quicken or whatever without having to ... following the primary partition and the first logical drive ). ... > logical drives in a single extended partition. ...
    (microsoft.public.windowsxp.hardware)
  • Re: Dual booting
    ... of Microsoft's dual boot scenario. ... The extended partition is not assigned a drive letter, ... BIOS reserves letters A and B for floppy drives, ... If WinXP Setup ...
    (microsoft.public.windowsxp.general)
  • RE: XP troubles/hal.dll
    ... At this point if I restart the pc I get the error message only. ... booting the system prviously I was not getting the Dell screen. ... >> set-up disks I get remove all disks from their drives and then pres the any ... >>> You haven't set boot order in computer bios. ...
    (microsoft.public.windowsxp.general)