XPe newbie needs some help

To all,

I downloaded the XPe 2007 SP2 and follow the tutorial of "Building and Deploying a Run-Time Image" very carefully. I have a SATA first drive as C: D: E: F: and a blank IDE second drive as G: for testing the image. In step #4, when defining the target Device setting - should I put in C: boot path 0 0 0 1 (in the Target Designer help) or G: boot path 0 0 1 1(in MSDN help). Seems like C: is the correct choice as when I use G:, the boot goes in a loop.

I copied the image to the G: drive and when I boot the second drive in the multi-boot I encountered the following error message during the component installing -

fba.exe application error

The instruction at "0x0319e132" referenced memory at "0x0000000c". The memory could not be "written"...

I cannot pass this point no matter what I try. I have a high res dual screen DVI graphic card and a few usb drives hooked to the PC.

Can someone shed some light in what I did wrong?

Thanks in advance,

Frank
.

Relevant Pages

  • RE: XP troubles/hal.dll
    ... At this point if I restart the pc I get the error message only. ... booting the system prviously I was not getting the Dell screen. ... >> set-up disks I get remove all disks from their drives and then pres the any ... >>> You haven't set boot order in computer bios. ...
    (microsoft.public.windowsxp.general)
  • Re: Windows XP hangs on startup after the windows logo shows
    ... When I disable automatic restart I get this error message: ... SATA RAID Controller " and then enter the Recovery Console ... v4.5.0.6448 with 2 Seagate Barracuda drives in RAID 0. ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: STOP 0x0000007E Error on installing Service Pack 2
    ... > ATI All In Wonder 9800 Graphics Card ... > 4) Disabling services that were not started up in Safe ... > Soundblaster and SATA drives. ... > Error Message at Startup Win XP ...
    (microsoft.public.windowsxp.setup_deployment)
  • Re: Unable to boot without CD present after fresh load of WinXP Pr
    ... I don't get any error message, ... How do I get the thing to boot withoput an XP cd ... The OS is install on an ... The drives are stripped. ...
    (microsoft.public.windowsxp.setup_deployment)
  • Re: I Forced a Shut Down During a Memory Dump...
    ... Background information on Stop Error message ... Check the cabling and connections to all drives. ... and then I get a "BOOT DISK FAILURE." ... There was a hardware problem ...
    (microsoft.public.windowsxp.general)
Loading