Re: FBA Rebooting when trying to use EWF
- From: "mykeaster" <easter.michael@xxxxxxxxx>
- Date: 20 Dec 2006 07:44:48 -0800
Some more information:
EWF Volume Configuration:
Number of Protected Volumes 1
Maximum Number of Overlay Levels 1
EWF Partition Size in KBytes 0
Disable Background Disk Defragmentation checked
Enable Hibernate-Once-Resume-Many Mode (HORM) unchecked
Protected Volume # 1
Start EWF Enabled checked
Enable Lazy Write unchecked
Disk Number 0
Partition Number 1
Overlay Type RAM
Optimization Option = Optimal Performance
in C:\Windows\fba\fbalog.txt (I shutdown and installed the harddrive on
a different machine)
There were 3 errors:
(Paths are not exact quotes)
PNP Flag section of FBA
FBAApplySecurityStringToRegKet Regkeysecurity failed! error 0x6
Registering Components section of FBA
FBARegQueue: DllRegisterServer /path/to/activeds.dll error 0x80040154
Processing Runonce section of FBA
FBAApplySecurityStringToRegKet Regkeysecurity failed! error 0x6
mykeaster wrote:
Here is what is going on. I am testing the capabilities of EWF/HORM
with a hard drive before I spend money on a CF card. I am using XPe SP2
with FP2007.
After getting the target information and importing it into Target
Designer, I added the bare minimum components to have a functional XPe
GUI Desktop.
Deploying the image is done using the Windows PE environment to mount a
network share and install the image using the command sdimgr
z:\blah.sdi /writedisk:0 /yes
Tested that, worked fine. No problems with FBA entering a reboot loop.
I add in the EWF components so that I can test EWF functionality. FBA
goes through its steps normally and reboots as it should. When the
system boots back up XP Splash Shows up, then the Reset Setup Flag
shows, then reboot. This continues indefinitely.
The only difference between my known good configuration and is the
change from NT Loader to the EWF NT Loader and the inclusion of the
other EWF Components.
boot.ini:
[boot loader]
timeout=0
default=multi(0)disk(0)rdisk(0)partition(1)\WINDOWS
[operating systems]
multi(0)disk(0)rdisk(0)partition(1)\WINDOWS="Microsoft Windows XP
Embedded" /fastdetect /noexecute=AlwaysOff
WERUNTIME.ini:
[RunTimeID]
RunTimeGUID={1D962156-8711-436D-B0A5-F55CAF002114}
RunTimePID=J9KHQ-38HJ3-9CKJG-GFRB6-XMXDY
RunTimeSKUCode=XPeCli
RunTimeOEMRev=
WEBuildDate=12/20/2006 1:21:51 PM
DeviceModel={00000000-0000-0000-0000-000000000000}
DeviceRole=0
DeviceSerial=
DeviceLicense=
.
- Follow-Ups:
- References:
- FBA Rebooting when trying to use EWF
- From: mykeaster
- FBA Rebooting when trying to use EWF
- Prev by Date: FBA Rebooting when trying to use EWF
- Next by Date: problem installing XPe Tools on XP SP2 machine
- Previous by thread: FBA Rebooting when trying to use EWF
- Next by thread: Re: FBA Rebooting when trying to use EWF
- Index(es):
Relevant Pages
|
|
