Re: Run ONCE
- From: "KM" <konstmor@xxxxxxxxxxxxxxxx>
- Date: Tue, 21 Nov 2006 10:50:37 -0800
Chris,
What you are looking for is probably FBA Generic command resource with the phase set late to > 8500. (RunOnce gives you less control
over the phase your command is launched)
It is hard to tell what your setup.exe does and why it is failing to start. Try a simple approach - launch CMD.exe during FBA (make
sure FBA is waiting for the CMD process to finish) and manually launch your setup.exe from there. You will see if it can be launched
on your image.
Make sure all the setup.exe's dependencies are in your image configuration.
--
=========
Regards,
KM
"Chris" <cblachon@xxxxxxxxxxx> wrote in message news:1164131404.436103.226250@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hello All,
I would like to launch a setup.exe after the fba has finished.
I tried to do it with RUNOnce reques in the extra ressource of the TD
project without success;
The tap runs on D:
The setup.exe is on C:
1/ So I tried first to put in the RUNOnce request File PATH :
C:/PATH/setup.exe
--> Error 0x3c in FBALOG
2/ I tried also to use the CMD :RUNOnce request File PATH :
D:\WINDOWS\SYSTEM32\CMD
+ Arguments : /C:PATH/setup.exe
And I had the CMD Windows command processor
--> Error 0x2 in FBALOG
I would not like that the setup.exe run during the tap process but only
at the first boot.
Many thanks.
.
- References:
- Run ONCE
- From: Chris
- Run ONCE
- Prev by Date: Re: Many More Bytes with SP2
- Next by Date: Re: Disable unused Services
- Previous by thread: Run ONCE
- Next by thread: Re: Many More Bytes with SP2
- Index(es):
Relevant Pages
|
|
