Re: CF errors during booting XPe - Compact Flash issues

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance

Bugcheck 0x7A (KERNEL_DATA_INPAGE_ERROR) indicates that the requested page
of kernel data from the paging file could not be read into memory. Are you
certain you dont have paging file enabled on your image?

Also, looking at the DDK documentation for 0x7A bugcheck - this is what is
says for the second parameter in the bugcheck (0xC0000185):

0xC0000185, or STATUS_IO_DEVICE_ERROR, is caused by improper termination or
defective cabling on SCSI devices, or two devices attempting to use the same
IRQ.

I'd probably check the h/w (including the connectors) and IRQs (if these are
controlled by jumpers on the adapter?).

Thanks,
Oren


"Scott Kelly" <scokelly@xxxxxxxxx> wrote in message
news:%23ftnFH%235GHA.1248@xxxxxxxxxxxxxxxxxxxxxxx
I have a non-EWF XPe load that boots fine on a 3.2gb IDE hard drive on my
target device (a PC like board using a Geode processor). I let it go
through FBA, etc. I then use Ghost to dupe the drive to a bigger 10gb IDE
drive. That 10gb drive can then boot XPe on my target device. So all is
well in the XPe loading and the duplication process. No swap file. No EWF
(I will turn on EWF RAM later.). The file system is FAT32 with a primary
1gb partition with the O/S and a secondary partition with 2gb for my app.

I now have a Samsung 8gb OEM Compact Flash card. The end stamp is
labeled: "MUCF08GSASI-05" No other markings on the CF card. I have NOT
done anything to flip the fixed/removable bit.... because I don't think I
need to because... I have an IDE (2.5" 44pin) to CF adapter. This lets me
disconnect my small HDDs and replace them with the CF cards. So I don't
THINK I need to flip the bit. If someone can confirm this - that would be
great. If I do need to modify the bit - then I could use help finding the
utility for Samsung. Also, I don't think I need to because...

When I try to boot my system with the CF card it actually starts to boot.
I see the white progress bar screen, then the XP splash screen with the
little blue progress (Kit car) kind of thingy. Then I get the blue
background screen with my mouse in the middle. Next up I get the
"Welcome" screen. That would normally by followed by the desktop. But
when I boot the CF card... it seems to stop there for a very long time
(like 1 hour) and then I sometimes get a blue screen of death:

KERNEL_DATA_INPAGE_ERROR
:
Technical information:
*** STOP: 0x0000007A (0xE13B42F8, 0xC0000185, 0xBF8AEE57, 0x0610F860)
*** win32k.sys - Address BF8AEE57 base at BF800000, DateStamp 3d6de5e5

Any thoughts on what I am doing wrong - or steps to further isolate the
problem?

Thanks,
Scott




.

Quantcast