Re: .NET 2.0 error during FBA
- From: "Brad Combs" <brad@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Fri, 22 Sep 2006 10:00:18 -0400
Hi Mark,
Can you try it with a 512MB partition? The size estimate from Target
Designer is just that, an estimate. Its usually off by a bit. If your
getting disk space errors during FBA then you'll probably have a problem
later too where the registry is flushed to disk at the end of FBA and you'll
get the famous "Save Hive .DEFAULT failed" dialog. I usually try to make
sure I have 50MB of free space beyond what is needed for XPe. Maybe you
could trim some components from the image to try and make it fit.
HTH,
Brad
"Mark Kraft" <m@xxxxxxxxxx> wrote in message
news:eC7vEek3GHA.4764@xxxxxxxxxxxxxxxxxxxxxxx
Hi,
I have just added the .net 2.0 component to my image. I am seeing a
problem
during FBA. A program CLR NAtive Image generator is running. It indicates
it
is compiling three assemblies. It fails indicating there is not enought
disk
space.
I have a 384 MB partition. The image is 307mB uncompressed based on TD
output.
I am running with HD, the resulting image will subsequently be placed on a
CF. I have 512MB device I wished to split as 384/128 for protected &
non-protected volumes.
Is there some min. size requirement to complete the fba process?
I did a quick search in the newsgroup I didn't find mention of this
problem.
Thank you, much appreciated!
--
Mark Kraft
Design Engineer
Lehigh Electric Products Co.
Tel: 610-395-3386
Fax: 610-395-7735
email: mkraft@xxxxxxxxxxxxx
website: www.lehighdim.com
.
- Follow-Ups:
- Re: .NET 2.0 error during FBA
- From: Mark Kraft
- Re: .NET 2.0 error during FBA
- References:
- .NET 2.0 error during FBA
- From: Mark Kraft
- .NET 2.0 error during FBA
- Prev by Date: .NET 2.0 error during FBA
- Next by Date: Re: .NET 2.0 error during FBA
- Previous by thread: .NET 2.0 error during FBA
- Next by thread: Re: .NET 2.0 error during FBA
- Index(es):
Relevant Pages
|
|