EWF multiple volume problem

Hi,

I am trying to protect partitions 1 & 4 on disk 0 with
C,E,F,G,unallocated. Please tell me what might be the cause of failing
ConfigureEwf(). See FBA log file below.

Thanks so much.


18:55:37 PM - [FBADoReboot] Sleeping...
18:55:47 PM - [FBADoReboot] Exiting process...
18:58:33 PM - ConfigureEwf() Start.

18:58:33 PM - Getting EWF config parameters from registry.

18:58:33 PM - Non El Torito disk configuration.

18:58:33 PM - EWF Partition Size = 24567 (KBytes), Levels = 1,
Volumes = 2.

18:58:33 PM - Protected Volume Config #0 :

18:58:33 PM - Disk= 0,Part= 1,DiskType= IDE,Type= Disk.

18:58:33 PM - Enable= Enabled, Optimize= 0, LazyWrite= N.

18:58:33 PM - Protected Volume Config #1 :

18:58:33 PM - Disk= 0,Part= 4,DiskType= IDE,Type= Disk.

18:58:33 PM - Enable= Enabled, Optimize= 0, LazyWrite= N.

18:58:33 PM - Found 1 Hard Disks.

18:58:33 PM - Disk #0 layout info:

18:58:33 PM - PRIMARY partition,start=0x0000000000007e00,
len=0x000000014588b200, type= 7

18:58:33 PM - PRIMARY partition,start=0x0000000145893000,
len=0x00000000c02f1000, type= 7

18:58:33 PM - PRIMARY partition,start=0x0000000205b84000,
len=0x00000000c02f1000, type= 7

18:58:33 PM - PRIMARY partition,start=0x00000002c5e75000,
len=0x00000000c02f1000, type= 7

18:58:33 PM - FREE partition,start=0x0000000386166000,
len=0x000000013ac00400, type= 0

18:58:33 PM - Failed to create EWF partition.

18:58:33 PM - ConfigureEwf() End, status = 0x80070057.

18:58:33 PM - [CallEntryPointThread] G:\WINDOWS\system32\ewfdll.dll,
ConfigureEwf
18:58:33 PM - [FBASetProgressText] Resetting Setup Flag...
18:58:52 PM - [FBADoReboot] Sleeping...
18:59:02 PM - [FBADoReboot] Rebooting system...

.

Relevant Pages

  • Re: Confusion over best practice: Disk-EWF cloned deployment
    ... Also I would review the partitioning guidelines for EWF in the XPe help ... But I can't create manually the EWF partition using ConfigureEwf. ... XPe Help suggests leaving EWF off until the final target. ...
    (microsoft.public.windowsxp.embedded)
  • Re: EWF error 1
    ... I don't see any error in FBA log either. ... try to set initial step of the EWF to disabled. ... That must be the partition created during fba. ... > 12:21:31 PM - ConfigureEwf() Start. ...
    (microsoft.public.windowsxp.embedded)
  • EWF problem on 512MB SANDISK CF
    ... I've a problem with RAM EWF on 512 MB sandisk CF. ... 23:13:19 PM - ConfigureEwf() Start. ... 23:13:19 PM - Non El Torito disk configuration. ... I've run the sandisk utility to set the flash as "Local disk". ...
    (microsoft.public.windowsxp.embedded)
  • Re: EWF error 0x57
    ... > 13:52:39 PM - ConfigureEwf() Start. ... > 13:52:39 PM - Getting EWF config parameters from registry. ... > 13:52:42 PM - ewfOpen returned invalid file handle. ... > The problem is that this error occours only on this flash card, ...
    (microsoft.public.windowsxp.embedded)
  • EWF
    ... ConfigureEwf() Start. ... 20:38:36 PM - Getting EWF config parameters from ... 20:38:37 PM - Searching for El Torito disk. ... 20:38:38 PM - Failed to create EWF partition. ...
    (microsoft.public.windowsxp.embedded)