Re: Boot Up problem: USB conflicts
- From: "Slobodan Brcin \(eMVP\)" <sbrcin@xxxxxx>
- Date: Mon, 20 Jun 2005 11:05:07 +0200
Rob,
I have seen similar behaviour on one of compueters, but everything is possible with bad device firmware or BIOS.
Try using different USB stick and different USB device. Also try updating BIOS if available.
USB Hub is also "USB device" but it make certain amount of delay since BIOS must enumerate USB HUB first and after that you device
connected to it. So device has a chance to fully initialize before it is enumerated by BIOS.
Regards,
Slobodan
"Rob" <robw@xxxxxxxxxxxx> wrote in message news:1119196218.893153.150390@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> I'm trying to get a USB memory stick and another USB device to boot up
> OK on my XPe machine. When just one of the two devices is plugged in
> everything is OK. However if both devices are plugged in to the USB
> bus, the machine never gets past the CMOS IDE drive check. I've found
> if I put a hub between the USB device and the PC then it boots up OK.
> Additionally if I plug the devices in once WPe is running things are
> OK.
>
> Has anybody come across anything like this before. ANy help is
> appreciated.
>
.
- Follow-Ups:
- Re: Boot Up problem: USB conflicts
- From: Rob
- Re: Boot Up problem: USB conflicts
- References:
- Boot Up problem: USB conflicts
- From: Rob
- Boot Up problem: USB conflicts
- Prev by Date: Re: Location of EWF overlay "flags" in disk partition?
- Next by Date: Re: Compact the reg file while componentize a large application
- Previous by thread: Boot Up problem: USB conflicts
- Next by thread: Re: Boot Up problem: USB conflicts
- Index(es):
Relevant Pages
|
