Re: repository files missing from final build

Tech-Archive recommends: Fix windows errors by optimizing your registry

KM,

Excellent! Thank you. This did indeed solve my problem with both
components. The driver was hanging on the *.cnt (which turns out to be a help
table of contents.) I saw that setting before, but never would have
attributed to the problem with my custom components. Apparently it's not
limited to just *.hlp... also the *.cnt *.txt *.rtf files, which make up the
balance of the missing files.

Thanks for the help and the prompt reply,

Paul.

"KM" wrote:

> Paul,
>
> Please clear up the "Do not copy help files for this configuration" option on the Configuration settings page.
> The same please do for your custom component included in the Configuration.
>
> Help files are likely needed to get the printer driver working (known issue).
>
> --
> Regards,
> KM, BSquare Corp.
>
>
> > Slobodan,
> >
> > Thanks for your response. I checked again and i can confirm that there are
> > no sub folders (it is flat.) There are 86 files, no folders in the
> > C:\Windows Embedded Data\Repositories\{A5D00BEC-C8B8-40F7-8B3F-B2F7B3D0315F}
> > folder -- the same which the component references in CDM. I've now noticed
> > this same problem with another printer driver component i've built. It only
> > has 3 files in the repository which should be copyed to system32, the first
> > two copy but it seems to have dropped the *.hlp from the build. I'm at a
> > loss short of manually copying the files to the build folder.
> >
> > Thanks,
> > Paul
> >
> > "Slobodan Brcin (eMVP)" wrote:
> >
> > > Paul,
> > >
> > > No advices since problem is strange, but one question instead?
> > >
> > > Are all files located in same flat repository folder?
> > > They must be in same source location, subfolders are not supported.
> > >
> > > Regards,
> > > Slobodan
> > >
> > >
> > >
> > > "Paul" <Paul@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
> > > news:324F6994-90E7-4CEB-9CFD-4E4753ED497A@xxxxxxxxxxxxxxxx
> > > > I've built and imported a custom component in CD that includes several
> > > > files.
> > > > Now, i
> > > > know that all the files are included after importing with CDM and they
> > > > SHOULD be
> > > > installed to the correct path, however less than half of the files in the
> > > > component
> > > > are actually making it to the final build folder.
> > > >
> > > > - there are 86 files referenced in my component in both TD and CM going to
> > > > the folder %11%\pdesk
> > > > - there are 86 files in my database after importing with CDM into the
> > > > repository.. the internal repository folder created by XPE CDM is
> > > > C:\Windows
> > > > Embedded Data\Repositories\\{A5D00BEC-C8B8-40F7-8B3F-B2F7B3D0315F}
> > > > - however of the 86 files, only 28 of the files are in the final build
> > > > folder
> > > > c:\builds\windows\system32\pdesk
> > > > - there are no errors during building of the component
> > > > - the missing files are side-by-side of files that are included. There
> > > > doesn't seem to be any logic to explain this situation.
> > > >
> > > > Any advice?
> > >
> > >
> > >
>
>
>
.

Relevant Pages