RE: How to configure the dual-channel display adapter settings?
From: Sorin C. (SorinC_at_discussions.microsoft.com)
Date: 10/28/04
- Next message: Sorin C.: "Setting brightness for a LCD display"
- Previous message: Richard: "Re: Award Bios"
- In reply to: Leszek: "How to configure the dual-channel display adapter settings?"
- Messages sorted by: [ date ] [ thread ]
Date: Thu, 28 Oct 2004 14:39:10 -0700
I've been using Matrox Millenium G550 Dual Display for a while and in the end
the better way was not to use the components I created after a tidious
process. Instead I've got better results installing and configuring the
driver the "clasic" way after FBA completed its job on the target system.
Then you can reseal the image (optional) and use an application like Norton
Ghost to deploy the image on other systems.
I hope this helps.
"Leszek" wrote:
> I'm trying to create an Windows XPE image (Evaluation Version for now) for
> typical PC-like system with dual-channel display adapter (Matrox Millennium
> P650). The system should start in the independent display mode which is not
> the default mode (default is the single display mode). When I open the Matrox
> component settings in the Target Designer I can modify the first channel
> settings only. How can I set the independent mode and the settings (e.g.
> resolution) for the second channel? Is it possible in the component
> definition or in the configuration file? Or do I need to make changes
> manually in the target system every time I deploy the new version?
>
- Next message: Sorin C.: "Setting brightness for a LCD display"
- Previous message: Richard: "Re: Award Bios"
- In reply to: Leszek: "How to configure the dual-channel display adapter settings?"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
