Re: SCSI Error

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

From: KM (konstmor_at_nospam_yahoo.com)
Date: 09/17/04

  • Next message: KM: "Re: Adding a component to an existing XPE system." 
    Date: Fri, 17 Sep 2004 01:38:20 -0700

    Terry,

    The first obvious question - did you set up boot.ini ARC path properly?

    Do you have Default value there?

    Since it is SCSI boot, you should not use "multi" in the ARC path but "scsi"
    (most likely scsi(0) in your case).

    You will also need Ntbootdd.sys at the root directory.

    This link may be helpful to you:
    http://www.microsoft.com/resources/documentation/Windows/XP/all/reskit/en-us/prmc_str_masc.asp

    KM

    > Hi all.
    >
    > I'm trying to boot by SCSI HDD.
    > I added about the SCSI components.
    >
    > SCSI and RAID controller
    > Device: SCSIAdapter
    > SCSI Port Driver
    > etc..
    >
    > But I saw the error during first boot.
    >
    > error massage:
    > "Windows could not start because of a computer disk hardware configuration
    > problem.
    > Could not read from the selected boot disk. Check boot path and disk
    > hardware.
    > Please check the Windows documentation about hardware disk configuration
    and
    > your hardware reference manuals for additional information"
    >
    > My SCSI Controller is Adaptec AIC-7901 Ultra320 SCSI Controller
    >
    > Does anybody know how to solve this problem ?
    >
    >
    >

  • Next message: KM: "Re: Adding a component to an existing XPE system."

    Relevant Pages

    • [HPADM] Re: [hpadm] disk problem
      ... Please check the disk using ioscan, ... Disk at hardware path 10/12.9.0: Hardware failure ... Product Identifier: SCSI Disk ...
      (HP-UX-Admin)
    • Re: Not able to boot from SCSI disk on SYM21002 but all other works
      ... It is a two channel SCSI hba with 16 bit SCSI and PCI interface. ... as I tried to boot the new system from the SCSI disk it presents only "PRESS ANY KEY TO REBOOT' and stops. ... So if any of the drives in the SCSI system could be found this would be enabled as C: ...
      (comp.periphs.scsi)
    • Re: boot sector f*ed
      ... The fbsd minimal installation that I had set up for recovery of the ... previous crash does not boot... ... touched the disk since last using it to look at the corrupted disk ... This sounds more and more like hardware troubles. ...
      (freebsd-questions)
    • Re: need help repairing this system... mount issues
      ... > i am able to boot, but i'm having some issues now. ... Uh -- which sort of disk drive do you have? ... driver, SCSI use 'da'. ... the device files are missing, you can generate them from single user ...
      (freebsd-questions)
    • Re: boot problem....ntldr could not open drive...
      ... - however upon reinstalling Windows XP ... goes below 7 (checklist no longer substantially matches original hardware) ... surely you need to use the correct XP recovery disk? ... which I was able to boot off. ...
      (microsoft.public.windowsxp.hardware)