Re: Problem with the pci.sys driver on Vista

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance



In the process of disassembling things to place that jumper perhaps you
lossened the monitor cable or even jostled the video card. Go through and
make sure everything is seated (though you most likely have done that).
Power down and let things sit, with power cable NOT plugged into wall power
for about 20 to 30 minutes. Then plug it in and power back up. If that does
not work, find the motherboard manual and use their "When all else fails
RESET" method.

Given that the BIOS you have is the latest release, I would go ahead and
monkey with that jumper and flash it. Unless you hear something bad about
the version to which you are change, it's usually a good thing to be upto
date.

--
The personal opinion of
Gary G. Little

"PhilTheGap" <oriane@xxxxxxxxxxxxxxx> wrote in message
news:62BC5AF8-DF03-405B-8C1F-E65D7CF79E32@xxxxxxxxxxxxxxxx

"PhilTheGap" <oriane@xxxxxxxxxxxxxxx> a écrit dans le message de
news:ujpL0WltIHA.3968@xxxxxxxxxxxxxxxxxxxxxxx
By the way, do you think that flashing the BIOS could fix the problem ?
I've tried...for the worse.
I explain: I've downloaded this
http://drivers.softpedia.com/get/BIOS/Others/ECS-RX480-A-BIOS-11f.shtml
for my Elite RX480-A motherboard. Then the BIOS has been upgraded but the
flash fails because I had to set a jumper beforehand on the motherboard.
I've decided to wait, then after a while I reboot.

Now he PC is running but nothing at all appears on the screen. I'm stuck !
I don't know what to do (I wrote from my office laptop).

What I don't understand is that I didn't flash anything...

Philippe


.



Relevant Pages

  • Re: Bios problem
    ... overclock and when I tried to reboot I get nothing. ... The motherboard has an overclock recovery procedure. ... is the power should be unplugged from ... when you use the jumper. ...
    (microsoft.public.windowsxp.hardware)
  • password problem
    ... If it is "AS SOON AS" you switch your pc on than I would ... think that it is a power on password. ... You will have to crack the case and find the jumper, ... to your motherboard manual or on another PC download the ...
    (microsoft.public.win2000.security)
  • Re: to clear CMOS
    ... Now that the jumper is in the 'clear CMOS' pins, for how long should I power up the computer before shutting down to replace the jumper to its original position? ... I might remove the CR2032 battery from its ...
    (microsoft.public.windowsxp.hardware)
  • I really need some help with FSB settings on motherboard
    ... Motherboard is a "MEW-VM rev 1.02". ... and the system came with a Celeron 400 MHz ... Note the FSB0 and FSB1. ... Then, I notice that there are pins, and a jumper on the bottom 3. ...
    (alt.comp.hardware.pc-homebuilt)
  • Motherboard FSB settings - I really need help here!
    ... Motherboard is a "MEW-VM rev 1.02". ... and the system came with a Celeron 400 MHz ... Note the FSB0 and FSB1. ... Then, I notice that there are pins, and a jumper on the bottom 3. ...
    (uk.comp.homebuilt)