Windows 2000 RAS Server and a Cisco Client Router

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

From: Mathias Gummert (mathias_at_gummert.de)
Date: 01/20/05 

Date: 20 Jan 2005 02:25:53 -0800

Thank´s Bill.

I managed to set up the above described configuration:

I have two LANs connected by a Cisco router and a Win 2000 Server Box.
The Cisco and the Win2K PC are connected by a dial-up link whereas the
Cisco router initiates the call.

Everything is fine - but only with the first attempt. When the link is
disconnected (by user or by the dialer idle timeout) and
re-established, there will be no routing over the W2K router. Pings
from one LAN into the other are not being replied.

Only when I stop and start the Win2K´s "Routing and Remote Access
Service", it works fine again.

Does anybody know a solution for that?

I´m using Win2K Server and SP4.

Thank´s a lot!

Mathias...

Relevant Pages

  • Re: Small network to Net setup suggestions.
    ... I've been out of the "routing" part of things for a long long time. ... Our server is just one of those Dell 2850 w/ built in ethernet ports ... Its definately still my NAT. ... > business-grade Cisco router, though they are of course first-rate units. ...
    (microsoft.public.win2000.networking)
  • Re: Network Setup from NT 4.0 to SBS 2003
    ... I understand that SBS won't be happy, ... have Cbeyond turn the DHCP off on the Cisco router (they have control of the ... Yes my plan is to take everyone off the NT server and put them on ... So if I turned off the DHCP on the router, ...
    (microsoft.public.windows.server.sbs)
  • Re: Help With DNS Through VPN
    ... >> Using a Cisco Router as VPN server and can connect fine to a Windows 2000 ... Are you running a site-to-site VPN with Cisco at one end ... where is that DNS server located? ...
    (microsoft.public.isa)
  • Re: DHCP Server shuts down Events 7036, 1054, & 1053
    ... So in a way, what you are saying, is that we can't trust the IP that the SBS ... Server is reporting as the source of the "competing" DHCP Server? ... Before we implemented the SBS Server, we had the Mitel VOIP doing DHCP. ... Cisco router was doing DHCP relay between the two VLAN/Subnets. ...
    (microsoft.public.windows.server.sbs)
  • Re: Need help with ipsec policy
    ... tunnel using a Win2003 server on one side and a Cisco Router on the ... The office with the Cisco router insists their setup is correct and they ... tried to get them to build a tunnel. ...
    (microsoft.public.windows.server.networking)