Re: Configure and Enable Routing and Remote Access Service grayed out
From: Bill Grant (not.available_at_online)
Date: 07/07/04
- Next message: Bill Grant: "Re: IPSec Passthrough on RRAS"
- Previous message: Bill Grant: "Re: Internet access while connected to VPN server"
- In reply to: Budhi Sidarta: "Configure and Enable Routing and Remote Access Service grayed out"
- Messages sorted by: [ date ] [ thread ]
Date: Wed, 7 Jul 2004 10:38:58 +1000
This is usually caused by the remote registry service being stopped. You
need to remote registry service running, even if the MMC and RRAS are on the
same system.
"Budhi Sidarta" <bsidarta@comcast.net> wrote in message
news:2711c01c463ae$64fbcf20$a601280a@phx.gbl...
> I have a Windows 2000 Server network with two NICs built
> in it. One NIC connected to the internet and the other one
> connected to an intranet. After I installed the second
> NIC, I can open RRAS MMC and the 'Configure and Enable
> Routing and Remote Access Service' tab was available and I
> was able to configure and do anything to set up the RRAS.
> But when I logged in again the next morning, the tab is
> just grayed out and the RRAS MMC didn't show any tree
> structure as usual although I was using Administrator
> account. I also cannot select the properties of the server
> and it always gives warning message: 'You do not have the
> required permissions to view the properties'. Does
> somebody have any experience with this problem? Any kind
> of help would be very appreciated.
- Next message: Bill Grant: "Re: IPSec Passthrough on RRAS"
- Previous message: Bill Grant: "Re: Internet access while connected to VPN server"
- In reply to: Budhi Sidarta: "Configure and Enable Routing and Remote Access Service grayed out"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
