Help! Lost in the forrest ? or NAT issue?

Tech-Archive recommends: Speed Up your PC by fixing your registry

Group,

I have a small network (about 10 Clients) that I'm trying to get a net
connection to.
I setup a server w/ Win2k3 and standard 192.168.x.x IPs and DHCP the
clients. I belive I got the DNS and DHCP working because clients are getting
they're IPs from the scope. I did setup DNS in AD and setup the domain
"xyz.loc" for the clients. For the net connection I set up a Cisco router to
NAT out the local IPs. Unfortunately I'm at basic levels in Cisco's IOS.
Under some configs I do get Global outside IPs for the clilents however the
client still can't get Net. I was woundering if there is something in AD that
needs to be done or that I'm missing. We were given a few static IPs from our
ISP (Verizion) and on a DSL line.

I was curoius if any one out there has a similar situation: Win2K3, local
DHCP, DNS on AD to Static IP DSL line w/ NAT to Net... With so many
acronyms no wounder I'm confused..

Any ideas or suggestions would be greately appreciated. I just want to get a
minimum config working so I have something to default to as I fine tune it.

I can say that I have a whole new respect for MSCE's and CCIE's
.

Relevant Pages

  • Re: Marina Roos Re: sbs2000: problems with exchange
    ... You better setup DHCP on the SBS, it will push all the necessary settings to ... your clients and it is a no-brainer. ... >> Emails are stored in the Exchange server, on the server and that is what ...
    (microsoft.public.backoffice.smallbiz2000)
  • Re: Vista clients became unresponsive after network move
    ... was mentioned that DHCP wasn't used, ... used, and all clients are static and incorrectly configured, I can ... network connection. ... IPs are static assigned IPs in 192.168.x.x range. ...
    (microsoft.public.windows.server.networking)
  • RE: Network configuration
    ... > To: Terrence Koeman ... >> Basically I have no clue what has to be setup etc. and if I ... >> clients and I need ipfw between the clients and the modem. ... -no ipfw rules and default to accept. ...
    (freebsd-questions)
  • Re: Vista clients became unresponsive after network move
    ... was mentioned that DHCP wasn't used, ... used, and all clients are static and incorrectly configured, I can ... All other IPs are ... network connection. ...
    (microsoft.public.windows.server.networking)
  • Re: SBS2003 setup w/out using POP3 Connector & the Anti-virus implicat
    ... > I setup a SBS2003 Standard Server a bit differently than I usually do. ... > the Inbox which resides on the client's account on the Exchange server. ... > Suite for SMB or Symantec Antivirus with Groupware protection to protect ... > clients and Exchange. ...
    (microsoft.public.windows.server.sbs)