Event ID 4319

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

From: JB (anonymous_at_discussions.microsoft.com)
Date: 11/15/04 

Date: Mon, 15 Nov 2004 00:06:54 -0800

I'm getting the same problem. The output from netstat
doesn't tell me anything obvious. But by removing all
other machines from the network and then adding them back
and rebooting one by one I found the machine that causes
the event. Trouble is I don't know why.
If anybody has any good ideas i'd be grateful.
John
>-----Original Message-----
>I am getting this error message in the Event Viewer every
two to three
>hours. I do what the error tells me to do and I run
netstat -n. Now it
>brings up the information that it is supposed to but I
don't know what I
>am looking for that would point out the offender and than
how do I
>correct or eliminate the offender? I have three computers
on my home
>network and they are all running fine. Only one computer
gets this error
>message. Any help would be appreciated and is needed.
>
>
>

Relevant Pages

  • Re: I cant understand Windows Explorer
    ... 'Network Places' either. ... machines that are turned off. ... duration from the router. ... we have four computers in one room and six in the other. ...
    (microsoft.public.windowsxp.general)
  • Re: install
    ... You just need to set up your network correctly. ... start by running the Network Setup Wizard on all machines (see ... Problems sharing files between computers on a network are generally caused ... by 1) a misconfigured firewall or overlooked firewall (including a stateful ...
    (microsoft.public.windows.vista.installation_setup)
  • Re: Changed from a software to a hardware firewall...now NETWORK PLACES wont display computer names
    ... to do before...open Network places and see the computers identified by their machine name. ... Two way communications OK between computers and internet and can ping by computer name - names just don't display in NETWORK PLACES. ... I'm beginning to wonder if the builtin 4 port switch works differently than the earlier plain vanilla switch - is it possible that the firewall is interacting in some way with the builtin switch such that I need to configure ... By way of a diagnostic, I think I'd change 2 machines back to static IP's, the same ones that they were previously assigned dynamically, see if those two can browse each other. ...
    (comp.security.firewalls)
  • Re: Workgroup Issue
    ... which is the Master Browser and which are not. ... They have a network hardware firewall/router in place and up to date ... Ping by IP address to different machines generally works ... Wait 4-5 minutes for Network Neighborhood to refind the computers ...
    (microsoft.public.windowsxp.network_web)
  • Re: Network path was not found
    ... This helped a lot to make the network config the same on all 3 computers. ... start by running the Network Setup Wizard on all machines (see ... by 1) a misconfigured firewall or overlooked firewall (including a stateful ...
    (microsoft.public.windowsxp.network_web)