Question about eTower 633id
- From: cce <cce@xxxxxxx>
- Date: Sun, 20 Aug 2006 09:33:15 GMT
I upgraded the OS from Windows ME to Windows 2000 on an eTower 633id.
I installed the modem driver available at this Web site:
http://www.priorityonesupport.com/downloads/emachines/ -- the modem is
a Connexant (56K ITU V.90 PCI Fax/Modem).
After installing the modem drivers (the modem "shows up), I am left
with the following hardware issue: the PCI Simple Communication
Controller is showing a configuaration problem, that is, no driver.
My question is, where would I get such a driver? I've searched around
for it and have had no luck. My impression is that this is a PCI -> MB
issue, not a modem issue, per se. If this is not the case, would it
make sense just to purchase a new internal modem?
The motherboard for the 633id:
Cognac Micro ATX (ATX V1.2 form factor) motherboard, TriGem, Korea
Intel Socket-370 (370pin PPGA Socket) for Intel FC-PGA Celeron CPUs
Integrating on-chip Graphics controller and Memory Controller Hub
(GMCH): Intel FW82810, as well as Intel I/O Controller Hub (ICH) and
AC 97' Controller.
I hope this makes some sense.
Thanks.
.
- Follow-Ups:
- Re: Question about eTower 633id
- From: paulmd@xxxxxxx
- Re: Question about eTower 633id
- From: paulmd@xxxxxxx
- Re: Question about eTower 633id
- From: DL
- Re: Question about eTower 633id
- Prev by Date: Re: W2k blue screen- win32k.sys PAGE_FAULT_IN_NON PAGER_ AREA
- Next by Date: Re: Question about eTower 633id
- Previous by thread: Re: W2k blue screen- win32k.sys PAGE_FAULT_IN_NON PAGER_ AREA
- Next by thread: Re: Question about eTower 633id
- Index(es):
Relevant Pages
|
