PPTP server

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

Dear all,

Does anyone knows how to setup the VPN server on a Dlink DI-804HV? I've set
the PPTP server as the following:

IP Address of the router: 192.1.1.1
PPTP server: Enabled
Virtual IP of the PPTP: 192.168.2.1
Authentication Protocol: MSCHAP

I've put the Tunnel Name as 'Test' and User Name and Password.

In the Client (Win2k), I've setup the properties of the VPN as:

in Security Tab, selected Advanced, Data Encryption=Optional Encryption
I allow only MS-CHAP

Type of VPN server i'm calling i put 'Automatic',


Then i try to connect using the user name and password specified just now.
After verifying User Name and Password, it disconnected and Error 628: The
connection was closed occurs.

in router log:

13:37:18 [START_CTRL_RQST] ESTABLISHED; index=0.
13:37:55 pptp_call_destroy>destory call 0 from tunnel 0
13:37:55 [pptp_call_destroy]: Closing PPTP call; [tunn=0], [call=0]
13:37:55 receive stop_ctrl_conn_rqst, tunnel 0
13:37:55 [peer](1)general request to clear.
13:37:55 [pptp_conn_destory]: Closing PPTP connection; index=0


What to do? i've opened the Port 1723 also.
--
Regards,
Tan Lee Yew,
Software Development Department,
MS Elevators Engineering Sdn Bhd,
Kuchai Lama, KL, Malaysia.

-----------------------------------------------------------------------
CONFIDENTIAL NOTE: The information contained in this e-mail is intended only
for the use of the individual or entity named above and may contain
information that is privileged, confidential and exempt from disclosure
under the applicable law. If the reader of this message is not the intended
recipient, you are hereby notified that any dissemination, distribution or
copying of this communication is strictly prohibited. If you have received
this message in error, please immediately notify the sender and delete the
mail. Thank you.


.

Relevant Pages

  • PPTP Server
    ... Does anyone knows how to setup the VPN server on a Dlink DI-804HV? ... IP Address of the router: ... PPTP server: Enabled ...
    (microsoft.public.win2000.networking)
  • Re: VPN in Win2003 Server
    ... configure the router or firewall to pass PPTP (TCP Port 1723 and IP ... Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net ... Thanks but the URL you gave me describes setting up vpn server with 2 = ... Setup server 2003 as VPN, this how to setup vpn server may help, = ...
    (microsoft.public.windows.server.networking)
  • Re: VPN to Linux server behind NAT router from XP Home?
    ... Postmaster wrote: ... >>I still can't get through my router however. ... >>establishing a PPTP connection to an ISP. ... > will just go to the VPN server. ...
    (comp.os.linux.networking)
  • Re: VNC under VPN
    ... you can connect to the VPN server via router or firewall program. ... program or use a router on the other client computer to block the posts, ...
    (microsoft.public.windows.server.networking)
  • Re: Router advice
    ... What do you mean by DDR firmware? ... I've had a Netgear WNR3500L for a couple of years now, first using DD-WRT, ... a Cisco router, but this has been perfectly fine. ... Only thing left for me to play with is getting a VPN server up and running ...
    (uk.comp.homebuilt)