RE: When I launch Exlorer.exe, the folders are not automatically displ

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

From: RayBccul-- (RayBccul_at_discussions.microsoft.com)
Date: 08/27/04 

Date: Fri, 27 Aug 2004 10:49:12 -0700

C:\WINNT\explorer.exe /n, /e, X:\

"L. Casey" wrote:

> When I launch Exlorer.exe, the folders are not automatically
> displayed. The syntax I use is: C:\WINNT\explorer.exe X:\
>
> Is there a command line switch that I am missing?
>
> Any suggestions helpful!!!
>

Relevant Pages

  • When I launch Exlorer.exe, the folders are not automatically displayed.
    ... The syntax I use is: C:\WINNT\explorer.exe X:\ ... Is there a command line switch that I am missing? ...
    (microsoft.public.win2000.general)
  • creating a setup project for Aug05 MDX redist
    ... are there any tutorials or example projects of how to do this with Aug05 ... the /InstallManagedDX command line switch is ...
    (microsoft.public.win32.programmer.directx.managed)
  • Re: scheduled tasks / cron jobs under Vista
    ... I checked this program from the command line ... and found out that all that was missing was a ... John Goche ...
    (microsoft.public.windows.vista.general)
  • Re: C2960 config - What do the commands do
    ... To enable visible sequence numbering of system logging messages, use the service sequence-numbers command in global configuration mode. ... Configure the system to automatically switch to summer time. ... This sybnet has the same network address what main network (the subnetted one) but longer subnet mask ... For chassis with 64 MAC addresses, STP uses the extended system ID plus a MAC address to make the bridge ID unique for each VLAN. ...
    (comp.dcom.sys.cisco)
  • ld.so.1: fatal ImportError: ld.so.1 No such file or directory
    ... you've GOT to finnd the missing file! ... This command above should go in your rc file, eg, ~/.tcshrc, ~/.cshrc, ... If you are still having trouble, ... try section-3 below, but then you're on your own. ...
    (comp.lang.python)