Re: Can't Debug COM Interface

> I've trouble to to debug a vb.net application implementing a com interface.

Could you please explain the configuration in a bit more details?

What components does the application consist of?
How are these components packaged? (EXEs and DLLs, managed/unmanaged,
languages used, etc.)
How are these components communicate with each other?
How is debugging configured? (Which component/project is used as a startup?)

And what version of Visual Studio is used?

Regards,
Oleg
[VC++ MVP http://www.debuginfo.com/]





.

Relevant Pages

  • 2.6.18.3 Lockup on Athlon MP
    ... I am sure it's not just a hardware issue, though, ... as well as the kernel configuration I am using. ... # ACPI (Advanced Configuration and Power Interface) Support ...
    (Linux-Kernel)
  • Slow Point to Point T1 Access Please Help
    ... interface FastEthernet0/0 ... DRAM configuration is 64 bits wide with parity disabled. ... minute output rate 7000 bits/sec, 7 packets/sec ... output buffer failures, ...
    (comp.dcom.sys.cisco)
  • Re: Slow Point to Point T1 Access Please Help
    ... interface FastEthernet0/0 ... DRAM configuration is 64 bits wide with parity disabled. ... minute output rate 7000 bits/sec, 7 packets/sec ... output buffer failures, ...
    (comp.dcom.sys.cisco)
  • Re: T1 lines go mad
    ... >> Can you post the interface configs as well as a show interface for each ... > Building configuration... ... > 0 output buffer failures, ...
    (comp.dcom.sys.cisco)
  • Cisco 857 Ethernet0 wont stay up unless constant ping is done.
    ... Current configuration: 5525 bytes ... interface ATM0.1 point-to-point ... ip nat inside source route-map SDM_RMAP_1 interface Dialer0 overload ... transport preferred all ...
    (comp.dcom.sys.cisco)
Loading