Re: stopping connectors from overlapping
Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance
The Ethernet shape has a "fake" set of connectors that are really just line
extensions from the same shape. You should connect with actual connectors
to get better routing behavior.
--
Mark Nelson
Office Graphics - Visio
Microsoft Corporation
This posting is provided "AS IS" with no warranties, and confers no rights.
"Jacques" <Jacques@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:2C06EEC3-E62B-4217-8F98-1DF8FEAC23BC@xxxxxxxxxxxxxxxx
I have a page with multiple shapes (servers) and they connect to multiple
ethernet shapes.
When I align my ethernet shapes above and below my servers I can only see
the connectors going to the highest (for those above the servers) and
lowest
(for those below the server).
is there any way to have the connectors not overlap?
.
Relevant Pages
- Re: Load balanced Bridgehead Servers
... How does NLB help you in that case and in what scenarios? ... Outlook Express users that use POP3/IMAP4 to access mail and SMTP to send ... and load-balancing for SMTP servers in that scenario. ... However, as far as Connectors and Bridgeheads go, this load-balancing & ...
(microsoft.public.exchange.design) - Re: I can receive but can not send form my Exchange 2000 SP3
... If so you could have some stale routing info the Exchange still think is ... off ALL your Exchange servers so that no Exchange server is running. ... In fact I do not have any connectors at all. ... am using DNS to send email. ...
(microsoft.public.exchange2000.connectivity) - Re: Load balanced Bridgehead Servers
... MVP - Exchange ... How does NLB help you in that case and in what scenarios? ... fault tolerance and load-balancing for SMTP servers in that scenario. ... However, as far as Connectors and Bridgeheads go, this load-balancing & ...
(microsoft.public.exchange.design) - Re: Unable to send email from 2nd (new) Exchange 2007 server
... You need NO connectors to send mail between the two servers. ... You need a send connector that sends to the "*" address space, and do not configure either of your Exchange servers as a smart host. ... What Queue has the msgs in it? ...
(microsoft.public.exchange.admin) - Re: Exchange 2003 - SMTP Connectors always using Default SMTP Server
... the local bridgehead servers are the same on both connectors? ... "Stefan" wrote in message ... I assume the concept of multiple Virtual Servers is ...
(microsoft.public.exchange.connectivity) |
|
