Help on parallel port programming under Windows XP

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

From: Phee Choon Beng (pheecb_at_stee.com.sg)
Date: 04/02/04 

Date: Fri, 2 Apr 2004 10:37:25 +0800

Dear all,

I have a problem in programming to read a pin from the parallel port under
Win XP. Anyone got any sample code to help me?

Best regards,

Choon Beng

Relevant Pages

  • Re: OT: DOS programming EPP
    ... There seems to be *no* specifications or equivalent circuits for the parallel port as implemented on the ASICs used in modern PCs. ... it is completely unknown as to the maximum safe sink current to a logic low pin or the maximum source current from a logic high pin. ... The EPP page assumes you did. ... This way of programming was used by the old "standard" printer interface. ...
    (sci.electronics.design)
  • Re: OT: DOS programming EPP
    ... >eXplicitly shows how to program a parallel port in the EPP mode, ... > However, no matter what i do, the nominally input printer pins (pin 1 ... >parallel port as implemented on the ASICs used in modern PCs. ... think you can just use DOS shell commands. ...
    (sci.electronics.design)
  • Re: OT: DOS programming EPP
    ... >>> parallel port as implemented on the ASICs used in modern PCs. ... >>> to a logic low pin or the maximum source current from a logic high pin. ... The EPP page assumes you did. ... This way of programming was used by the old "standard" printer interface. ...
    (sci.electronics.design)
  • Re: how to connect an LED to PC
    ... Is a 2 k-ohm resistor big enough? ... PWM motor control via parallel port. ... in a 16 pin DIP and provides 7 darlington transistors ... but the gate voltage is low. ...
    (sci.electronics.design)
  • Re: OT: DOS programming EPP
    ... There seems to be *no* specifications or equivalent circuits for the parallel port as implemented on the ASICs used in modern PCs. ... it is completely unknown as to the maximum safe sink current to a logic low pin or the maximum source current from a logic high pin. ... The EPP page assumes you did. ... CONTROL bit 5 defaults low. ...
    (sci.electronics.design)