Re: How do i change numerics into binary numbers?

Good morning Rick, Larry, Mayayana

Let me start afresh.

Input:
1) Message ID bits 1-6
2) Data Terminal bits 7
3) Data Indicator bit 8
4) User ID bits 9-38
5) Current status bits 39-42
6) Rate of turn bits 43-50
7) Speed bits 51-60
8) Positional accuracy bits 61
9) Longitude bits 62-89
10) Latitude bits 90-116
11) Direction bits 117-128
12) True Heading bits 129-137
13) Repeat indicator bits 144-145
14) Reserved bits 146-149
15) Spare bits 150
16) State of communication bits 151-168

A typical entry: bit description
1) message 1 000001
2) not available 1
3) not available 0
4) 127 000000 000000 000000 000001 111111
5) mobile 0000
6) 1.1 degree/minute 000001 01
7) 61.2 Km/hr 100110 0100
8) Low 0
9) 27degrees 5minutes 000011 110111 111101 001001 0000
10) 5degrees 5mins 000001 011101 000101 000010 000
11) 95.9 degrees True 001110 111111
12) 351 degrees True 101011 111
13) not repeated 00
14) "reserved" 0000
15) "spare" 0
16) UTC indirect 01
1 frame remaining 01
until a new slot is
selected,UTC hour
and minute follows
15:17 01111: 0010001

*UTC- Co-ordinated Universal Time

So I will be combining all the bits together after this.

000001 ---> 1
100000 ---> P
000000 ---> 0
000000 ---> 0
000000 ---> 0
011111 ---> O
110000 ---> h
000001 ---> 1
011001 ---> I
100100 ---> T
000001 ---> 1
111011 ---> s
111110 ---> v
100100 ---> T
100000 ---> P
000010 ---> 2
111010 ---> r
001010 ---> :
000100 ---> 4
000011 ---> 3
101111 ---> g
111010 ---> r
111111 ---> w
101010 ---> b
000000 ---> 0
010101 ---> E
111001 ---> q
000100 ---> 4

The final output should be : 1P000Oh1IT1svTP2r:43grwb0Eq4

I realised why the output does not follow 6 bit ascii table, this is because
Decimal 0 of 6bit table is tied to Decimal 48 of Standard ascii (which the
character is 0) and so on and so forth. meaning, first decimal of 6bit table
is tied to 48th decimal of standard ascii from Decimal 0 to 63 of 6bit to
Decimal 48 to 77 of standard ascii. This is to reproduced the desired output
characters I need from the standard ascii table.

Is it clearer now? Thank you all, for your time.

"Rick Rothstein (MVP - VB)" wrote:

Perhaps you need to start fresh.

Agreed!

Describe the input, and describe the output, give full details.
Then give an example of sample input values and what they
should produce at the output. Do a complete example,
supplying all inputs and output, and be certain everything is
correct.

.