Re: Change Master Page of Publishing Content Page

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance



bernadou wrote:
When using the Publishing with Workflow site templage in MOSS 2007, I
can apply a master page to an entire site's conent pages using site
settings (simple stuff). What I need to do, is change the master
page for a single existing content page.

In Sharepoint Designer it seems as though you should be able to do
this, but, when attempting to do so, all the options are grayed out.

Is there a way to instruct a page to use a master page other than the
site default master?

Thanks,
Bernie

You can use the sharepoint designer. The options are greyed out because you
must be in contributor mode. Go To Tools->Contributor settings and check
Allow unlimited use of sharepoint designer.

Hope this helps

--
Madhur Ahuja

http://madhurahuja.blogspot.com


.



Relevant Pages

  • Re: Questions about sis7012+snd_intel8x0 sound card problem
    ... > config my sound card, ... surround volume control and the master volume control ... amixer set Master 50 should also set master ... One caveat -- I'm not sure if the settings are ...
    (Debian-User)
  • Re: UDMA & mode 4
    ... Master will be on the end, ... PCs that have trouble with hard drives bigger than that. ... > connector ideally is meant for the master mode & which one ... > In some HDDs there are 5 jumper settings while in some ...
    (microsoft.public.windowsxp.hardware)
  • Re: UDMA & mode 4
    ... Master will be on the end, ... PCs that have trouble with hard drives bigger than that. ... > connector ideally is meant for the master mode & which one ... > In some HDDs there are 5 jumper settings while in some ...
    (microsoft.public.windowsxp.newusers)
  • Re: Grub Problem (?) Installing FC4 dual boot with Win2K
    ... > run any better than one with separate Master/Slave settings. ... > Opinion mode OFF ... Setting the jumpers to master / slave on even a cable where pin 28 is ...
    (Fedora)
  • [SLE] RESOLVED Re: [SLE] CD burning problems with 9.1 AGAIN!
    ... The new settings: dvdrom on secondary as master, dvdrw on secondary as slave. ...
    (SuSE)