Re: Problems syncing my IPAQ 5450

Tech-Archive recommends: Speed Up your PC by fixing your registry

From: KDE (knott_me_at_NOSPAM.hotmail.com)
Date: 03/08/05 

Date: Tue, 8 Mar 2005 10:57:32 -0700

additionally, you didnt mention, but if you have the cradle connected
through a USB hub, you might try connecting it directly to the machine.

"Raj Pillai" <YouMeAndTheMail@Softhome.net> wrote in message
news:%23AME5RAJFHA.1280@TK2MSFTNGP09.phx.gbl...
| Hi,
|
| Try doing the following:
|
| 1. Click Start, then click Run. Type the following:
|
| devmgmt.msc
|
| Click Ok. This should open up the device manager.
| 2. Connect your Pocket PC via USB and you should see
| an entry at the bottom Windows CE USB Devices.
| 3. Right-click and uninstall the entry for the PPC.
| 4. Remove the device and reboot computer.
| 5. Perform a soft reset and connect the device.
|
| You could ask your friend too to try the steps listed above. See if it
| helps either of you solve the problem.
| --
| Regards,
| Raj Pillai
| http://www.pocketpcfaq.com/raj
|
|
| "mexflyfish" <com.hotmail@orgullodemexico> wrote in message
| news:6qgXd.17718$hU7.8335@newssvr33.news.prodigy.com...
| > PC: Win XP, 450Mhz PII, dial up ISP, USB sync
| >
| > My problems began a month ago. When I drop my HP IPAQ 5450 into the
| > cradle,
| > I'd get the warning message that "usb device is not recognized". I'd
| > retry
| > a couple times and finally active sync would begin.
| >
| > For other reasons, last weekend I reformatted my hard drive and reloaded
| > all
| > software. I downloaded and installed Win XP SP1 and SP2. I still have
| > the
| > same problem with my PDA and sync. I downloaded Active Sync 3.8 and
same
| > issues. Now the PDA will even kick itself off-sync during the middle of
| > the
| > cycle for unknown reason. Also it may take 4 or 5 attempts of dropping
| > the
| > PDA into the cradle before its recognized.
| >
| > Could there be a cradle problem?
| >
| > Additionally, a friend reports similar problems with his IPAQ. He can't
| > sync via USB on computer 1, but it works in serial mode with serial
cable.
| > He can sync using same cradle on PC 2 in USB mode.
| >
| > Any ideas?
| >
| > Thanks for any help.
| >
| >
|
|
|
|

Relevant Pages

  • Re: Dell x50 USB Travel Sync Cable
    ... Both the provided USB cradle and the USB sync cable work pretty much in the ... on, but will not charge. ...
    (microsoft.public.pocketpc)
  • Re: unknown device-problem: cant sync
    ... soft reset, hard reset, uninstalling USB driver, installing USB ... it clicked it must be the connection in the cradle where my pda sits. ... and drivers etc. try a different USB connection, ...
    (microsoft.public.pocketpc.activesync)
  • Problems syncing my IPAQ 5450
    ... I'd get the warning message that "usb device is not recognized". ... a couple times and finally active sync would begin. ... PDA into the cradle before its recognized. ... a friend reports similar problems with his IPAQ. ...
    (microsoft.public.pocketpc.activesync)
  • Re: ActiveSync not working with X51V
    ... It could be a hardware problem with the usb cradle. ... I connected my PDA to my laptop through the USB and same results as my ... First insert the Pocket PC in the cradle and check on the Device Manager ... After a massive IR synchronization (Contacts and ...
    (microsoft.public.pocketpc.activesync)
  • Re: Usb Dell Axim Sync disappears reappears
    ... Put device in cradle or plug in sync cable ... heard again and again ...go in device manager Dell Axim Sync USB is ... disconnects and shows available as the sound of connect and disconnect ...
    (microsoft.public.pocketpc.activesync)