Re: IMAP server closed the connection, Error Code: 0x800CCCDD

Tech-Archive recommends: Speed Up your PC by fixing your registry

Sounds like your ISP closes the IMAP connection after receiving the NOOP
command from Outlook. Since you can't configure Outlook to stop sending
this command, perhaps your ISP will reconfigure their server to not close
the connection after receiving this command from an IMAP client like
Outlook.

"dysonsphere" <dysonsphere@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:A2CB8601-61D8-4D5C-8185-4C7049FAC8C7@xxxxxxxxxxxxxxxx
I frequently get the error message:
Your IMAP server closed the connection. This can occur if you leave the
connection idle for too long.

Lost mailbox lock
Protocol: IMAP
Server: ahsmail.uwaterloo.ca
Port: 143
Error Code: 0x800CCCDD.

I get my mail but it is very annoying to have to close the dialog box all
the time.

Is there a way around this?






.

Relevant Pages

  • Outlook hangs when accessing IMAP inbox
    ... The Imap inbox has a shortcut on the Outlook menubar. ... Network connection is via 100-mb ethernet connection. ... Imap account, then scrolls down to the inbox, everything works fine. ...
    (microsoft.public.outlook.general)
  • Re: IMAP server closed the connection, Error Code: 0x800CCCDD
    ... command from Outlook. ... Since you can't configure Outlook to stop sending ... Your IMAP server closed the connection. ...
    (microsoft.public.outlook)
  • Re: Outlook 2002 and IMAP: Fails to stay connected to IMAP server
    ... Having the exact same problem with Gmail IMAP and Outlook 2007. ... My issue is that Outlook will lose connection to Gmail's IMAP service ... POP3 check to indicate I have mail in case the connection has failed. ...
    (microsoft.public.outlook)
  • Using SSL with Outlook - reloaded
    ... Outlook 6 and also Outlook Express 6 refuse to send the appropriate certificate. ... As a quick test I tried to connect with IE via https to the secure IMAP port. ... In the course of the SSL connection setup I was asked to select one of my ...
    (microsoft.public.outlook)
  • Re: What is the switch to start outlook using RPC so that you can see the connection status?
    ... the connection status using RPC over HTTPs so that you can diagnose ... I don't know a command line option - just hold the CTRL key and click on the ... Outlook icon in the system tray, and you should see the connection status ...
    (microsoft.public.exchange.clients)