Re: Word v.X doesn't print tables properly in Panther

anonymous_at_discussions.microsoft.com
Date: 03/16/04 

Date: Mon, 15 Mar 2004 20:43:45 -0800

P.S. - This is not a slight change in measurements. It is knocking inches off
of the top and bottom (or sides, depending on orientation).

>-----Original Message-----
>Try removing and replacing your printer driver. It sounds as though the
>driver for the printer you are using is not correctly reporting the
>boundaries of the print area.
>
>Make sure that you are formatting the document for that specific printer
and
>not "Any Printer".
>
>Having gone up to a level of the operating system, certain printing
>measurements may change slightly. Go up to 10.3 before you spend any
>serious time on this issue, because it all may change again :-)
>
>Hope this helps
>
>
>This responds to article
<1101701c3f429$aec35820$a501280a@phx.gbl>, from "B
>Maxwell" <truder1@mac.com> on 16/2/04 12:10 PM:
>
>> Printing tables in Word v.X in Panther causes the tables to lose portions
near
>> the edges (top and bottom or left and right depending on orientation of
the
>> page), as if the margins are set inside the table boundaries. Does not
>> happen to versions prior to update 1.2 (but there are other issues then).
Did
>> not happen with any update in Jaguar.
>
>--
>
>Please respond only to the newsgroup to preserve the thread.
>
>John McGhie, Consultant Technical Writer,
>McGhie Information Engineering Pty Ltd
>Sydney, Australia. GMT + 10 Hrs
>+61 4 1209 1410, mailto:john@mcghie.name
>
>
>.
>

Relevant Pages

  • Word v.X doesnt print tables properly in Panther
    ... Printing tables in Word v.X in Panther causes the tables to lose portions near ... the edges (top and bottom or left and right depending on orientation of the ...
    (microsoft.public.mac.office.word)
  • Re: Millers errorbars
    ... It is not statistically significant (the errorbars are MUCH ... Consider a radio antenna with 1 volt peak to peak of noise and 1 ... Miller, on the other hand, made 40 measurements of THE SAME VALUE ... (fringe position at a given orientation), ...
    (sci.physics.research)
  • Re: OT: Question about highway signs in the country
    ... They understand how their long-term bottom line would benefit. ... even among business leaders there is too much short-term thinking. ... measurements -- which would never have happened had the U.S. gone all-metric. ... so it's not really a surprise either that highway ...
    (rec.gambling.poker)
  • Re: Jonathan West re Duplex Macros
    ... > from top to bottom on the left page, ... > This layout is often used with clipboards. ... It might be that you need to set the paper orientation in the printer ... setting this property is over-ridden by the Page Setup settings in ...
    (microsoft.public.word.vba.beginners)
  • Re: G91 G28 Z0
    ... > position (top or bottom of part depending where your Z0 is) then it goes ... If you program it in G91 the tool rapids home from wherever it is, ...
    (alt.machines.cnc)