Re: PEAP with MS-CHAPv2 authentication on IAS

I now tried a few things with the attributes of the RAS Regulation and
it seems that the MTU was too big to handle, so I defined it as
smaller, and now it seems like the communication is just running fine,
except when the Switch is sending the change cipher and encrypted
handshake message, there is no response from the radius. The switch
tries three times and then gives up. does anyone know what the problem
could be? I'm at a loss..

Ed

.

Relevant Pages

  • Re: Panic in 6.2-PRERELEASE with bge on amd64
    ... interface is enough to completely panic the driver and then the kernel, ... I added some sysctls and found it annoying to have to do down/up ... Similarly for the mtu ioctl. ... As this was connected to a gigE switch with mtu left at 1500 I supposed ...
    (freebsd-stable)
  • Re: Odd tracepath and ping behavior when using a 9000 byte MTU
    ... >> I've recently switched my network to gigabit. ... I can switch all the machines to a 9000 MTU and ... >> it decides the path MTU should be 1492. ... >> on wire packets on the receiving end with ethereal. ...
    (comp.os.linux.networking)
  • Re: 100Mbps Ethernet Speed/Efficiency
    ... > It's an SBC, ... Copper trace PCI, but no plug-in connectors. ... mtu is actaully tuned on a per-interface basis. ... assuming your switch support jumbo frames. ...
    (Fedora)
  • Re: dev/em: Link is not up until 2 seconds after "ifconfig up"
    ... I've fixed the speed and mediaopt both of emand ... switch, but it shows autoselect state and no carrier... ... em1: flags=8843mtu 1500 ...
    (freebsd-current)
Loading