Re: Choose IP address to run IAS on

Go to the IAS server properties and enter the IP address followed by a colon
(:) and then the port numbers for the ports to listen on. Then restart IAS.

"Nathan" <nathan@123> wrote in message
news:%23W6dXoV%23FHA.1484@xxxxxxxxxxxxxxxxxxxxxxx
> Hi,
>
> We have 1 x NIC but 2 x IP addresses allocated on a Windows 2003 server.
> How can I get IAS to use the address of my choice? Not the one it wants to
> use?
>
> Thanks
>
> Nathan
>


.

Relevant Pages

  • Re: ipsec failing on boot and server in block mode
    ... a port conflict will occur if the DNS server allocates a port that is ... IAS but there may be other services that will have a conflict. ... If the IPSEC service fails to start, the server will be running in Block ...
    (microsoft.public.windows.server.sbs)
  • Re: IAS - Ports problem
    ... It's going to be hard to detect this using a port scan or telnet because IAS ... Register Server in Active Directory) ... I have configured RADIUS clients and Remote access policy in the IAS ...
    (microsoft.public.windows.server.networking)
  • Re: Choose IP address to run IAS on
    ... >> colon and then the port numbers for the ports to listen on. ... >> restart IAS. ... >>> Nathan ...
    (microsoft.public.internet.radius)
  • Re: Choose IP address to run IAS on
    ... > colon and then the port numbers for the ports to listen on. ... > restart IAS. ... this information is covered in the Help topic "Configure IAS port ...
    (microsoft.public.internet.radius)
  • Re: IAS - Ports problem
    ... The IAS is supposed to answer on port 1812 and 1645, but when I telnet to these ports from a wks there is no respond. ... Try running a port scanner to verify that those ports are open, or use netstat on the server to see if that shows a listening port. ... Not all servers will respond to a telnet request, so this isn't necessarily an accurate way to determine that a port is open and the sever is responding. ...
    (microsoft.public.windows.server.networking)
Loading