Re: IAS Remote Access Policies : Destination server and Protocols.

You would use IP filters for this. They can be configured via the Remote
Access Policy. Go to the properties of your policy and you will be able to
configure Input and Output filters on the IP tab.

For more informatoin on how setting up IP filters you can review this link:

http://www.microsoft.com/technet/prodtechnol/windowsserver2003/library/ServerHelp/9400ff7e-83ef-46c0-9a44-d5ac90aae437.mspx

Or you can find the same infornmatoin in the IAS help by looking for 'Packet
Filters' on the Index tab.

-Jeff


"Zul J" <mlist@xxxxxxxxxxxx> wrote in message
news:%23txPuR1WFHA.3716@xxxxxxxxxxxxxxxxxxxxxxx
> Hi,
>
> How do I limit the user access to only certain server only through IAS
> remote access policies ? Is it possible to limit the protocols as well
> like http or ftp ?
>
> Thanks.
>
> Rgrds,
> Zul
>


.

Relevant Pages

  • Re: xp VPN into Win2k
    ... Did you use the Wizard to configure the VPN server? ... disable the filters it creates: ... Open the Routing and Remote Access Snapin. ... Open the IP Routing container and then select the General container. ...
    (microsoft.public.win2000.ras_routing)
  • Re: Will IR Illuminator work with any CCD Camera?
    ... the lcd or evf while someone holds a TV remote and punches a few buttons ... just past red in the spectrum. ... If the camera sees a 510nm orange light both the Red and Green filters will ...
    (sci.electronics.basics)
  • Re: IAS Remote Access Policies : Destination server and Protocols.
    ... They can be configured via the Remote ... > Access Policy. ... > configure Input and Output filters on the IP tab. ... > Or you can find the same infornmatoin in the IAS help by looking for ...
    (microsoft.public.internet.radius)
  • Re: ISA not loading new packet filters
    ... there are several filters that I have been unable to get to ... I have enabled both 8080 (for outgoing access to remote ...
    (microsoft.public.win2000.security)