Re: Can not show every page

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance

Hello Sherry

Thanks for your step by step help. I have done everthing like you discribed.
But It still doesn't work. I always get the message 200 OK or Service
Unavailable.

The secound rule, I had to disable, because the all website was blocked.

Kind regards
Dani

""Sherry Jia"" <v-shjia@xxxxxxxxxxxxxxxxxxxx> wrote in message
news:L48YhfR3JHA.2064@xxxxxxxxxxxxxxxxxxxxxxxxx
Hi Dani,

I would like to share my knowlege about create the new protocol.

To create a new protocol, please follow the below steps.

1. Open the ISA management console->click on Firewall Policy.
2. Click on the Toolbox tab on the right pane. Click on New->Protocol.
3. Edit the protocol connection as follows

Protocol type: TCP
Direction: Outbound
Port range: from 80 to 80
Secondary Connections: No

Note: The web proxy filter will not bind to the new protocol.

Then you need to create the access rule to allow the access. The rule can
be defined as follows,

Rule name: Allow access channelpartner
Action: Allow
Source: Internal
Destination: You can create the computer set which includes the IP address
of the channelpartner website. Or you can create the domain name set to
include the FQDN of this problematic website.
Protocol: The new protocol you created previously
Apply to: All users

Then please create the access rule to allow the access to this specific
website using the default HTTP protocol. the rule can be defined as
follows,

Rule name: Deny access channelpartner using default HTTP protocol
Action: Deny
Source: Internal
Destination: You can create the computer set which includes the IP address
of the channelpartner website. Or you can create the domain name set to
include the FQDN of this problematic website.
Protocol: HTTP
Apply to: All users

Please move these two rules to the top of the policy list. The allow rule
should be in high priority than the deny rule.

If you have any question or problem, please do not hesitate to contact us
at your first convenience. We are glad to be of assistance.

Sincerely,

Sherry Jia
Microsoft Partner Online Support

Get Secure! - www.microsoft.com/security


====================================================
When responding to posts, please "Reply to Group" via your newsreader so
that others may learn and benefit from this issue.
====================================================
This posting is provided "AS IS" with no warranties, and confers no
rights.
====================================================





.

Relevant Pages

  • Re: Can not show every page
    ... I would like to share my knowlege about create the new protocol. ... You can create the computer set which includes the IP address ... include the FQDN of this problematic website. ... Deny access channelpartner using default HTTP protocol ...
    (microsoft.public.isa)
  • Shiva Smart Tunneling (SST)
    ... analysis of the security of this protocol? ... Audit your website security with Acunetix Web Vulnerability Scanner: ... Cross site scripting and other web attacks before hackers do! ...
    (Pen-Test)
  • Re: Can not show every page
    ... I have tryed to create a HTTP Protocol without proxy filter, ... Can you give me a help, how to create a new prtocol. ... I get the same message when I try to open the website from my Windows ... Server 2008 client through ISA Server 2006 SP1 ...
    (microsoft.public.isa)
  • IE 6 does not play Flash Movie correctly
    ... I have a Flash6 movie on a website ... which runs fine until I switch the protocol to https and check the "do not ...
    (microsoft.public.windows.inetexplorer.ie6.browser)
  • Browsers Supported
    ... Vendor's website have an obligation to support website standards like W3C. ... You wouldn't think of using a one-off email protocol or a property Internet ...
    (microsoft.public.office.misc)