Re: route

Hi,

I have a Isa Server with 3 networks, inside, external ans DMZ. I have
configure the DMZ with route no NAT. I have a public range for the dmz, and I
want that the server browse with its IP. But It browser with external IP. How
can I do?

disable the Webproxyfilter for the HTTP protoocl (but this disables also the HTTP filter etc. for all HTTP traffic).
Other option: Create a new HTTP2 protocol, disable the webproxyfilter for this protocol and use it for your firewall rule in the DMZ.

regards Jens
www.nt-faq.de



.

Relevant Pages

  • Re: Retrieve documents from HTTP site
    ... you could consider creating an endpoint in your DMZ that simply ... than a local virtual directory setup on the actual BizTalk Server 2006 R2 ... When you say you want to retrieve messages from HTTP, ...
    (microsoft.public.biztalk.general)
  • Re: Retrieve documents from HTTP site
    ... you could consider creating an endpoint in your DMZ that simply ... than a local virtual directory setup on the actual BizTalk Server 2006 R2 ... When you say you want to retrieve messages from HTTP, ...
    (microsoft.public.biztalk.general)
  • Re: Server hosting problem with Fortigate60
    ... > b) Internal to DMZ ... Service Port HTTP ... There are still a few ways to mess this up -- putting other policies above ...
    (comp.security.firewalls)
  • Re: OWA DMZ
    ... I recommend that you install an ISA server in your ... DMZ and configure it to proxy the HTTP traffic, ...
    (microsoft.public.exchange.admin)
  • Re: Exchange 2003 web access through port 443 with Cisco 515E pix
    ... Mark Arnold [MVP] wrote: ... > If he can get in on HTTP then does that pre-suppose the fixup is ... > The reaon I interjected was about the OWA server in a DMZ. ... having the fixup protocol turned off you can still create an access ...
    (microsoft.public.exchange.setup)