Nat Router config

From: Dave Whyte (dwhyte_at_101digitalservices.co.uk)
Date: 06/02/04

  • Next message: John Kisha: "Re: Private IP Addressess visible" 
    Date: Wed, 2 Jun 2004 23:38:16 +0100

    Hi all,

    I have the suggested setup running for SBS2003, two nic's one Lan the other
    going to a Belkin Nat router and then to a Cable Modem.
    Dynamic IP address, ISA Server etc.

    When I log-in to the Router config web page from a firewall client
    machine, it can take up to ten minutes for the password to be verified and
    some screens sometimes do not login properly, i.e. deny access.

    I have tried all the usual; checking LAT, putting in the web address of the
    router in the IE proxy bypass settings etc.

    Also, I have the same problem but much worse with a Belkin Wireless
    access point.

    Any suggestions?
    Thanks,
    Dave

  • Next message: John Kisha: "Re: Private IP Addressess visible"

    Relevant Pages

    • Nat Router
      ... going to a Belkin Nat router and then to a Cable Modem. ... When I log-in to the Router config web page from a firewall client ... some screens sometimes do not login properly, i.e. deny access. ...
      (microsoft.public.windows.server.networking)
    • NAT Router
      ... going to a Belkin Nat router and then to a Cable Modem. ... When I log-in to the Router config web page from a firewall client ... some screens sometimes do not login properly, i.e. deny access. ...
      (microsoft.public.windows.server.sbs)
    • RE: deny access
      ... This should give you a good start to ACL's on the router. ... If you tell us what type of mail sever you have we can probably tell you how ... to setup deny lists for access and relaying. ... Subject: deny access ...
      (Security-Basics)
    • Re: how to block access for outer LANs?
      ... > internet through one router; there are also switch between our LANs and ... Use a firewall and deny access to the IP addresses of ... If these computers have a Static IP then use the IP ...
      (microsoft.public.windowsxp.general)