Re: DVD in DMA Modus
From: Ahmed Martens (nospam_at_freenet.de)
Date: 05/01/04
- Next message: Superpam: "System startet in Rot - Schrift !Grafikkarte defekt?"
- Previous message: spy: "Ein USB-Anschluß defekt"
- In reply to: Sven Maehl: "Re: DVD in DMA Modus"
- Next in thread: Sven Maehl: "Re: DVD in DMA Modus"
- Reply: Sven Maehl: "Re: DVD in DMA Modus"
- Messages sorted by: [ date ] [ thread ]
Date: Sat, 1 May 2004 17:22:16 +0200
Hallo Sven,
Sven Maehl wrote:
> "Ahmed Martens" <nospam@freenet.de>
>
>> ich habe ein Problem mit meinem DVD-Laufwerk. Es ist an einem
>> sekundären IDE-Kanal angeschlossen. Dort wird er aber immer nur im
>> PIO-Modus betrieben.
>> Lt. BIOS sollte aber alle Kanäle auto(matisch) im DMA-Modus
>> betrieben werden. Kann ich jetzt irgendwie WinXP zwingen bzw.
>> umstellen das mein DVD auch im DMA betrieben wird.
>
> Während des Bootvorganges, wird im Bios welcher Übertragungsmodus
> angezeigt?
>
> Welches Mainboard/Chipsatz ist verbaut?
>
>
> MfG Sven Maehl
im Boot-Vorgang folgende Meldung:
Sec.Master: DVD ; ATA 33 (WinXP-LW=D:)
Sec.Slave: CD-RW ; ATA 33 (WinXP-LW=E:)
Im Geräte-Manager unter IDE ATA:
Gerät 0: Ultra-DMA-Modus 2
Gerät 1: PIO
DVD: MATSHITA DVD-ROM SR-8588
CD-RW: HL-DT-ST CD-RW GCE-8520B
lt. Sandra:
SiSoftware Sandra
Mainboard
Manufacturer : MICRO-STAR INTERNATIONAL CO., LTD
MP Support : 1 CPU(s)
MPS Version : 1.40
Model : MS-6533
System Memory Controller
Location : Mainboard
Error Correction Capability : None
Number of Memory Slots : 2
Maximum Installable Memory : 2GB
Bank0/1 - A0 : None None None None DIMM Synchronous SDRAM 512MB/64
Bank2/3 - A1 : Empty
Chipset 1
Model : Silicon Integrated Systems (SiS) SiS645DX CPU to PCI Bridge
Bus(es) : ISA AGP PCI USB
Front Side Bus Speed : 4x 133MHz (532MHz data rate)
Maximum FSB Speed / Max Memory Speed : 4x 133MHz / 2x 166MHz
Width : 64-bit
IO Queue Depth : 8 request(s)
Priority Master Queue Depth : 7 request(s)
Chipset 1 Hub Interface
Type : MUTOL
Width : 16-bit
Full Duplex : No
Multiplier : 1/1x
Logical/Chipset 1 Memory Banks
Bank 0 : 512MB DDR-SDRAM 2.5-3-3-7CL 1CMD
Width : 64-bit
Refresh Rate : 7.80µs
Power Save Mode : No
Fixed Hole Present : No
[...]
Port Connector
PRIMARY IDE : None - ATA / None
SECONDARY IDE : None - ATA / None
FDD : 8251 FIFO - Floppy Disk / None
COM1 : Serial Port 16450 - 9 Pin Dual Inline / DB-9 pin male
COM2 : Serial Port 16450 - 9 Pin Dual Inline / DB-9 pin male
LPT1 : Parallel Port ECP/EPP - DB-25 pin female / DB-25 pin female
Keyboard : Keyboard - PS/2 / PS/2
PS/2 Mouse : Mouse - PS/2 / PS/2
USB : USB - None / None
Performance Tips
Warning 2533 : Disabled host controllers are present. Check BIOS
settings.
Notice 224 : SMBIOS/DMI information may be inaccurate.
Warning 2507 : Mainboard has too few memory slots. Upgrading the memory
may be difficult or expensive.
Tip 2511 : Some memory slots are free so the memory can be easily
upgraded.
Tip 2546 : Large memory modules should be ECC/Parity.
Tip 2536 : System has no SMBus/i2c/BMB bus support.
Tip 2 : Double-click tip or press Enter while a tip is selected for
more information about the tip.
Lt. Nero-Test kann mein CD-RW-Laufwerk bis zu 52-fach brennen.
Lt. Sandra ist das DVD-Laufwerk gnadenlos langsam. DVD kann ich aber
mit anschauen (kein ruckeln). Nero reduziert eine On-Fly-Kopie auf
16-Fach zurück, obwohl lt. Rechnung das DVD-Laufwerk CD's mit 48-Fach
lesen sollte.
Hast Du vielleicht eine Idee.
Gruß Ahmed
- Next message: Superpam: "System startet in Rot - Schrift !Grafikkarte defekt?"
- Previous message: spy: "Ein USB-Anschluß defekt"
- In reply to: Sven Maehl: "Re: DVD in DMA Modus"
- Next in thread: Sven Maehl: "Re: DVD in DMA Modus"
- Reply: Sven Maehl: "Re: DVD in DMA Modus"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|