Re: Multiple SMTP addresses for uses/messages being rejected

Hi,

Make sure that the old address is also included in a recipient policy.
Otherwise the server won't accept mails for the domain.

Leif

<doug.dockter@xxxxxxxxxxxxxxxxxxxx> wrote in message
news:1150488686.667241.173390@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Our e-mail domain used to be xxxx.com. About a year ago we changed it
to yyyy.com. In Exchange you can have multiple SMTP e-mail addresses.
So we kept both the new address (yyyy.com and marked it as the primary)
and the old address. It appears since we upgraded to Exchange 2003
that any e-mails sent to xxxx.com are getting rejected - see the error
below. I still have the SMTP service running on another server because
of GFI MailEssentials. This has a remote SMTP domain set up for
xxxx.com as it does for yyyy.com with a smart host IP address of the
Exchange server. This is the same setup as before the Exchange
conversion except for changing the IP address to point to the new
Exchange server.

Message delivery to the remote domain xxxx.com failed. The error
message is An SMTP protocol error occurred.


The SMTP verb which caused the error is RCPT. The response from the
remote server is 550 5.7.1 Unable to relay for xxx@xxxxxxxx



.

Relevant Pages

  • [NT] Vulnerability in Exchange Server Could Allow Arbitrary Code Execution (MS03-046)
    ... Get your security news from a reliable source. ... In Exchange Server 5.5, a security vulnerability exists in the Internet ... an unauthenticated attacker to connect to the SMTP port on an Exchange ...
    (Securiteam)
  • RE: strange email errors
    ... you to check the relay configuration on the SBS server. ... please restart the SMTP virtue server and Exchange ... Please also refer to the following steps to create a new SMTP Connector to ...
    (microsoft.public.windows.server.sbs)
  • Re: Exchange issues
    ... Are you up to date on all your Service Packs, both Windows and Exchange? ... > all traffic on port 25 to the SBS Exhange server. ... I suspected SMTP relaying becuase ... > You should verify that the server really isn't an open relay: ...
    (microsoft.public.exchange2000.admin)
  • Filtering email on ISA
    ... Unless you choose to create a new IIS SMTP Virtual ... Server, ordinarily you will want to Server Publish ... directly to the Exchange SMTP, ...
    (microsoft.public.isa)
  • RE: Exchange will not send messages with attachments
    ... Cisco pix firewall with the SMTP filtering enable ... data following the Microsoft Exchange Server XEXCH50 command. ... Please first check the settings on the hardware firewall, ... First let's use nslookup to query the remote SMTP server IP address: ...
    (microsoft.public.windows.server.sbs)
Loading