Recovery of the Exchange database

Tech-Archive recommends: Fix windows errors by optimizing your registry

From: Wizard (wizard_at_NOSPAM.zykes.com)
Date: 04/16/04 

Date: Fri, 16 Apr 2004 14:57:35 +0200

Greetings all,

Win 2000 SP4, Exchange 2000 SP3, all patches.

The HDD with the C partition, had a horrible sound for
15 seconds before the "blus scree" apeared. Normaly
not a problem, change the HDD and recover from backup
with Beckup Exec.

The problem is that the last sucsessful backup was 4,5
months ago, and no one have done anything with it :-\

Exhcange is installed on another HDD raid set, so all the
datas from Exchange should be availible.

Is it possible for me to change the defective HDD, install
Windows. Install Excahnge in an other location, than the
prvious. And then revover all the nessecery datas from the
old installation?

If it's possible, can anybodu tell me how?

Wizard

Relevant Pages

  • Re: New build - halt on ACPI Controller
    ... on the hdd from a previous install attempt. ... landed up using the rear panel mains isolator switch to switch it off as ... The use of partition analysis and repair tools unearthed a further two ...
    (uk.comp.homebuilt)
  • Re: Xp install problem
    ... Anna wrote: ... I am attempting to install xp after fitting a new HDD following a "failure" of the old one. ... When I reach the point during the install where the "install devices" starts, I get the stop code 0x000000BE. ... If so, it would be worthwhile to remove the graphics card, ensure your onboard graphics capability is enabled and see if the install will succeed. ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Xp install problem
    ... I am attempting to install xp after fitting a new HDD following a ... When I reach the point during the install where the "install ... graphics/video card. ... You're certain all your connections & configuration of components ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Xp install problem
    ... I am attempting to install xp after fitting a new HDD following a "failure" of the old one. ... When I reach the point during the install where the "install devices" starts, I get the stop code 0x000000BE. ... If so, it would be worthwhile to remove the graphics card, ensure your onboard graphics capability is enabled and see if the install will succeed. ... You're certain all your connections & configuration of components including the new HDD are proper and your motherboard is properly seated? ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Installing new hard drives
    ... Hard disk cloning software, "x copy", I ... a "fresh" install and not be able to access the old drive to copy files (I ... old 40 GB HDD to the new one. ... offer to assist me install the new drives still stands I might be taking ...
    (microsoft.public.windowsxp.hardware)