Exchange 2007 - No incomimg mail - URGENT HELP REQUIRED



Hi,
I posted this question already a while a go but did not get an answer. So
trying now again. we recently installed EX2007 with the following
configuration:
1 Server for Hub, CAS and Mailbox, one as Edge transport server. The Edge
Server is connected with one NIC directly to the internet (we did not set up
a firewall yet) and with the other NIC to the switch where all other servers
are connected to (like DC, etc)

I followed quiet precisly the instructions of the set up and we are able to
send outbound mail without problem. When I try to send an email or answer one
of the sent mails, I get the following error:

A configuration error in the e-mail system caused the message to bounce
between two servers or to be forwarded between two recipients. Contact your
administrator.

So we tried also with a differnet mail system and got this error:

SMTP-connection with IP [xx.xx.xx.xx:25] herzustellen Thu 2007-11-01
18:58:06: * IP xx.xx.xx.xx in connection failure cache for up to 5 minutes
due to previous connection failure(s)

I have no idea what could cause this error, any help is very much appreciated.
Thank you

--
Udo
.



Relevant Pages

  • Re: Still cant connect to RWW or OWA remotely
    ... the router. ... match the broadband connection, the two NIC firewall, the remote ... Windows IP Configuration ... Ethernet adapter Server Local Area Connection: ...
    (microsoft.public.windows.server.sbs)
  • Re: Outgoing POP3 email missing/lost/not received
    ... SUMMARY OF SETTINGS FOR CONFIGURE E-MAIL AND INTERNET ... Internet Connection Wizard. ... NETWORKING CONFIGURATION SUMMARY ... Alternate DNS server: 209.165.254.12 ...
    (microsoft.public.windows.server.sbs)
  • Re: Help - Stalled Swing Migration
    ... I have cleared out the event logs and rebooted. ... Check the database connection and make sure the database is running. ... The DHCP Server has detected that it is running on a DC and has no credentials ... configuration settings you have specified when running the CEICW. ...
    (microsoft.public.windows.server.sbs)
  • RE: Error configuring CEICW (newbie user)
    ... On the Connection Type page, click Broadband, and then click Next. ... next to Preferred DNS server and next to ... configuration settings for an existing firewall device. ... If you still get error when run CEICW, ...
    (microsoft.public.windows.server.sbs)
  • Re: Help - Stalled Swing Migration
    ... Very frustrating because the server is otherwise behaving correctly. ... I have cleared out the event logs and rebooted. ... Check the database connection and make sure the database is running. ... configuration settings you have specified when running the CEICW. ...
    (microsoft.public.windows.server.sbs)