Spk1 on Cluster Install Problem
Tech-Archive recommends: Fix windows errors by optimizing your registry
Just configured a two node cluster with Exchange 2k3, on Win2k3 Ent Edition.
The cluster config went fine, installed exchange with no problems either.
Installed spk1 for exchange per Microsofts Instructions (KB Article 867624)
this seemed to go fine on the first node. But, when I went to upgrade the
virtual exchange server I got in an error loop. The two errors I keep getting
are:
Facility:c0070035 Network path not found
Facility:c00706ab Network address in invalid.
I am stumpted here; anyone have any ideas?
--
bikermike mcse, mcsa win2k
.
Relevant Pages
- RE: cannot uninstall Exchange 2003 from a DC
... I think you absolutly should be able to deinstall Exchange from a DC. ... I installed Exchange on a member server and migrated all of the mailboxes off ... Error code 0XC0070035: The network path was not found. ...
(microsoft.public.exchange.setup) - Re: Exchange 2003 Ent Cluster Installation
... have created a two node cluster on Win2003 Enterprise SP1 and all updates. ... have created the IP, Name, MSDTC, and Phys Disk resources and fail over is ... I have installed Exchange 2003 Ent on each node along with SP2. ...
(microsoft.public.exchange.setup) - Re: Exchange for DR
... Have you considered Exchange 2007? ... Site A= Production with Exchange 2003 2 node cluster. ... I am using IBM SVC (san volume controller) to replicate FC SAN storage ...
(microsoft.public.exchange.design) - Re: Four Node cluster
... Thanks a lot, i got a fair idea about 4 node cluster, can you suggest me ... Deploying Exchange Server 2003 in a Cluster ...
(microsoft.public.exchange.admin) - External URLs
... When I'm trying to set up external URLs for Exchange 2007 services, ... An unexpected error has occurred and a Watson dump is being ... The network path was not found. ...
(microsoft.public.exchange.admin) |
|
