Re: How to make the event sink run automaticaly

sorry, But i am also facing the same problem.

Best Regards
Parveen Beniwal

Henning Krause [MVP - Exchange] wrote:
Hello,

no, by client location I mean on networks of my clients.

Event sinks must be registered directly on the server.

Could you post your COM+ application settings here? Perhaps that may help.

Best regards,
Henning

"Parv" <Parveen.Beniwal.Daffodil@xxxxxxxxx> wrote in message
news:1154422156.084541.243200@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hi hennig
I want to know here one thing that what u mean here by client
locations. Do u mean that you deployed EventSink on the client machines
rather than the ExchangeServer itself. I am asking this as i have
heared that EventSink can be used and registered on the server only and
we can't register EventSinks from any client machines.
Please make me confirm if i am thinking something wrong ?

Best Regards
Parveen Beniwal



Henning Krause [MVP - Exchange] wrote:
Hello,

I haven't heard yet of this behavior - the COM+ application should start
automatically with the server - even more as you have configured the
component to run in a dedicated server process. Is this service set to
start
automatically or set to manual (See the services MMC).

I have several eventsinks deployed at client locations, and none show
these
behavior.

Best regards,
Henning Krause


"BMW" <BMW@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:4D888824-0318-48B7-BE04-187084FF2626@xxxxxxxxxxxxxxxx
Hi Henning,

After the server restarted or shut down, I must restart the COM+
application
too; otherwise the sink is no effect. Do you tell me how can I set up
my
COM+
application can start even the server restart?

"Henning Krause [MVP - Exchange]" wrote:

Hello,

the Event should be triggered after a restart of the Exchange store.

But there is (was) an issue with Store-wide event sinks and Exchange
2003,
perhaps this applies to you:
http://support.microsoft.com/kb/872822/en-us.

Otherwise, are there any events logged in the Eventlog?

Best regards,
Henning Krause

"BMW" <BMW@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:B937A66E-E464-4393-9503-0FA430BB2B1D@xxxxxxxxxxxxxxxx
How to make the event sink run automatically

I succeeded to add the COM+ application and to register the event
sink.
It
works fine. However, after the server shuts down. The COM+
application
cannot
start automatically. I already set it as a system application and
run
application as NT Service.
Please tell me what I should do. Do I need to write a script? If so,
would
you have any example or site which I should look at?

Thanks in advance.





.

Relevant Pages